Open Access. Powered by Scholars. Published by Universities.®

Engineering Science and Materials Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Engineering Science and Materials

Experimental Validation For The Theory Of Blisters’ Instabilities, Hongtian Zhu Jan 2018

Experimental Validation For The Theory Of Blisters’ Instabilities, Hongtian Zhu

Mechanical Engineering Graduate Theses & Dissertations

Blister formation is a universal problem that can be witnessed within a wide range of contents. It is first documented as a side effect of syringomyelia and other diseases. Later on, the forming of blisters are also observed during the cell apoptosis, which leads to the hypothesis that it could have some intricate relationships with the death of living organisms. Other than biological problems, blister forming is also a common phenomenon in thin film technologies. Therefore, the research in the forming of blisters is essential and critical in both engineering and science fields.

In this thesis, we study the problem ...


Lamb Waves With Conical Dispersion At Zero Wavenumber, David M. Stobbe Jan 2018

Lamb Waves With Conical Dispersion At Zero Wavenumber, David M. Stobbe

Mechanical Engineering Graduate Theses & Dissertations

Lamb waves are guided elastic waves in plates. These waves are dispersive, with the frequency and wavenumber related by the well-known Rayleigh-Lamb equation. Generally, at zero wavenumber the dispersion curves are parabolic and the waves are non-propagating thickness resonances. For distinct values of Poisson’s ratio, however, degeneracy can occur between thickness resonance modes. At these coincidence frequencies the dispersion curves become linear and in a three-dimensional representation the dispersion surface is shaped like a cone. This behavior is referred to as conical dispersion. Waves excited at coincidence frequencies maintain the infinite phase velocity associated with thickness resonances but transport ...


Finite Strain Micromorphic Elasticity, Elastoplasticity, And Dynamics For Multiscale Finite Element Analysis, Farhad Shahabi Jan 2017

Finite Strain Micromorphic Elasticity, Elastoplasticity, And Dynamics For Multiscale Finite Element Analysis, Farhad Shahabi

Civil Engineering Graduate Theses & Dissertations

This study stands as an attempt to consider the micro-structure of materials in a continuum framework by the aid of micromorphic continuum theory in the sense of Eringen. Since classical continuum mechanics do not account for the micro-structural characteristics of materials, they cannot be used to address the macroscopic mechanical response of all micro-structured materials. In the “representative volume element (RVE)” based methods, classical continuum mechanics may be applied to analyze mechanical deformation and stresses of materials at the relevant micro-structural length-scale (such as grains of a polycrystalline metal, or sand, or metal matrix composite, etc), but when applying standard ...


Roll-To-Roll Atomic Layer Deposition Of Ultrabarriers, Alexander Yersak Jan 2016

Roll-To-Roll Atomic Layer Deposition Of Ultrabarriers, Alexander Yersak

Mechanical Engineering Graduate Theses & Dissertations

Atomic layer deposition (ALD) is a bottom-up, gas phase, thin film deposition technique based on sequential, self-limiting binary surface reactions. The precise sub-nanometer film thickness control and conformal nature of this process have led to various commercial applications of ALD. However, ALD films are most commonly deposited in batch processes at low pressures, which raises throughput and/or cost concerns for many otherwise promising applications. This problem can be solved by spatial ALD (S-ALD) which is a version of the ALD technique where the precursors are separated in space rather than time. We have demonstrated the first atmospheric pressure roll-to-roll ...