Open Access. Powered by Scholars. Published by Universities.®
Engineering Science and Materials Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Engineering Science and Materials
The Effect Of Oxygen On Properties Of Zirconium Metal, Jie Zhao
The Effect Of Oxygen On Properties Of Zirconium Metal, Jie Zhao
Doctoral Dissertations
The influence of oxygen on the thermophysical properties of zirconium has been investigated using MSL-EML (Material Science Laboratory Electromagnetic Levitator) on ISS (International Space Station) in collaboration with NASA (National Aeronautics and Space Administration), ESA (European Space Agency), and DLR (German Aerospace Center). Zirconium samples with different oxygen concentrations was subjected to multiple melt cycles during which the thermophysical properties, such as density, viscosity and surface tension, have been measured at various undercooled and superheated temperatures. Also, there are melt cycles for verifying the solidification mechanism. Similar samples were found to show anomalous nucleation of the solid for certain ranges …
High Strain Rate Dynamic Response Of Aluminum 6061 Micro Particles At Elevated Temperatures And Varying Oxide Thicknesses Of Substrate Surface, Carmine Taglienti
High Strain Rate Dynamic Response Of Aluminum 6061 Micro Particles At Elevated Temperatures And Varying Oxide Thicknesses Of Substrate Surface, Carmine Taglienti
Masters Theses
Cold spray is a unique additive manufacturing process, where a large number of ductile metal micro particles are deposited to create new surface coatings or free-standing structures. Metallic particles are accelerated through a gas stream, reaching velocities of over 1 km/s. Accelerated particles experience a high-strain-rate microscopic ballistic collisions against a target substrate. Large amounts of kinetic energy results in extreme plastic deformation of the particles and substrate. Though the cold spray process has been in use for decades, the extreme material science behind the deformation of particles has not been well understood due to experimental difficulties arising from the …
Analyses Of Densely Crosslinked Phenolic Systems Using Low Field Nmr, Jigneshkumar Patel
Analyses Of Densely Crosslinked Phenolic Systems Using Low Field Nmr, Jigneshkumar Patel
Doctoral Dissertations
A uniform dispersion of reactants is necessary to achieve a complete reaction involving multi-components, especially for the crosslinking of rigid high-performance materials. In these reactions, miscibility is crucial for curing efficiency. This miscibility is typically enhanced by adding a third component, a plasticizer. For the reaction of the highly crystalline crosslinking agent hexamethylenetetramine (HMTA) with a strongly hydrogen-bonded phenol formaldehyde resin, furfural has been traditionally used as the plasticizer. However, the reason for its effectiveness is not clear. In this doctoral thesis work, miscibility and crosslinking efficiency of plasticizers in phenolic curing reactions are studied by thermal analysis and spectroscopic …