Engineering Science and Materials Commons^™

Materials Selection Of 3d Printing Filament And Utilization Of Recycled Polyethylene Terephthalate (Pet) In A Redesigned Breadboard, Mark Keanu James E. Exconde, Julie Anne A. Co, Jill Z. Manapat, Eduardo R. Magdaluyo Jr.

Goal 12: Responsible Consumption and Production

The demand for a novel and sustainable alternative materials for 3D printer filaments has been knowingly increasing. One alternative source for the filament is to reuse and recycle post-consumer plastic products, which is also a compelling approach to conserve energy and sustain the environment. Thus, this study is focused on the materials selection of virgin polymer resins and recycled post-consumer plastics for use in 3D printer filaments. A multi-criteria decision method of Elimination and Choice Expressing the Reality (ELECTRE) was utilized to determine the best materials for 3D printer filaments. The study has shown that the virgin low-density polyethylene (LDPE) …

Development Of Experimental And Finite Element Models To Show Size Effects In The Forming Of Thin Sheet Metals, Jeffrey D. Morris

University of New Orleans Theses and Dissertations

Abstract

An experimental method was developed that demonstrated the size effects in forming thin sheet metals, and a finite element model was developed to predict the effects demonstrated by the experiment. A universal testing machine (UTM) was used to form aluminum and copper of varying thicknesses (less than 1mm) into a hemispherical dome. A stereolithography additive manufacturing technology was used to fabricate the punch and die from a UV curing resin. There was agreement between the experimental and numerical models. The results showed that geometric size effects were significant for both materials, and these effects increased as the thickness of …

Design And Control Of Fiber Encapsulation Additive Manufacturing, Matt Saari

Mechanical Engineering Research Theses and Dissertations

This work presents the design, development, and analysis of the Fiber Encapsulation Additive Manufacturing (FEAM) system developed at the Laboratory for Additive Manufacturing Robotics \& Automation at the Lyle School of Engineering at Southern Methodist University. The innovation introduced by FEAM is the ability to insert a continuous fiber of different material into the flowing extrudate. Correctly positioning the fiber feed inside the extrudate while turning the fiber in arbitrary directions is a critical aspect of the technology. This will allow for the full exploitation of the capabilities of the FEAM technology to produce robotic components that actuate and sense. …

Mechanical And Tribological Behaviour Of Treated And Untreated Moringa Oleifera Pods Fiber Reinforced Epoxy Polymer Composite For Packaging Applications, Prakash Sampath, Senthil Kumar V.S Dr

Journal of Applied Packaging Research

Researchers now focus on the use of natural fiber polymer composites materials for packing applications. This attention is due to their low cost and renewable characteristics. Fabrication of composites with the use of renewable resources has many benefits of alternating from an appropriate management and reduction in industrial wastages, ecofriendly behaviour to cost effectiveness. The artificial fibers in packing industries can be replaced by natural fibers in the areas where stiffness and high strength are not the primary requirement. In the last decade the use of Natural fibers in the place of artificial fibers for reinforcements in epoxy resin matrix …