VLSI and Circuits, Embedded and Hardware Systems Commons^™

Smart Collar, Gretchen T. Woodling, Sean Moran, Justen Bischoff, Jacob Sindelar

Williams Honors College, Honors Research Projects

The Smart Collar is a universal pet tracker, designed to be small and exceedingly comfortable for any pet to wear. GPS technology is used to locate the device, allowing the user to track their pet, via a smart phone application. This application can be used to program the device, view maps of their pet’s location and history of travel. Operating primarily on Long Range Wide Area Network (LoRaWAN) for data transfer, the device consumes very little power, allowing for several days of run-time per charge of the battery. Boasting no monthly service fees, The Smart Collar provides pet owner’s an …

Tidalsim Senior Project Report, Kent Zhang, Colin Vandervoort

Computer Engineering

Throughout the course of this project, our team helped the Cal Poly Biological Sciences department refine an intertidal zone simulator. The aim of this device is to allow any marine biologist to easily simulate a vast range of tidal zones in order to test animal behaviors within these zones. Another goal of this project is to make each simulation tank independent from the others by using a single microcontroller to handle all inputs and outputs of the system as well as logging all relevant data. The current system is set up so that a separate microcontroller handles dissolved oxygen and …

Design And Fabrication Techniques Of Devices For Embedded Power Active Contact Lens, Errol Heradio Leon

Master's Theses

This thesis designed and fabricated various devices that were interfaced to an IC for an active contact lens that notifies the user of an event by detection of an external wireless signal. The contact lens consisted of an embedded antenna providing communication with a 2.4GHz system, as well as inductive charging at an operating frequency of 13.56 MHz. The lens utilized a CBC005 5µAh thin film battery by Cymbet and a manufactured graphene super capacitor as a power source. The custom integrated circuit (IC) was designed using the On Semiconductor CMOS C5 0.6 µm process to manage …

Continuous Hand-Tool Leveling Device, Shaun Villa Koide

Electrical Engineering

To produce clean and precise cuts, hand-tools (e.g. knives and saws) must maintain a consistent angle of orientation during the entire cutting process. The Continuous Hand-Tool Leveling Device mounts on the desired hand-tool and the user inputs the desired angle of the cutting plane. The device utilizes a microcontroller unit (MCU) and accelerometer to implement real-time angle measurement. When using a hand-tool, the device uses an LED that indicates that the hand-tool’s angle deviates from the user-set desired angle, which prevents any potential mistakes from occurring due to user error. The device easily mounts on many common cutting tools. Additionally, …

Lyfi, Kianoosh Salami, Justin Cotton, Elush Shirazpour

Electrical Engineering

This paper will cover the steps necessary to design, build, and manage networkable smart light switches over WiFi via a mobile application. It contains a microcontroller running a real time operating system, a WiFi module, a Java server with SQLite databasing, and a mobile phone application.

LyFi is designed to turn on/off and dim household lights while only requiring the same installation procedure as a less capable dimmer switch. Once installed and connected to a network, LyFi will self-discover and configure. The server automatically propogates a database of nodes where any mobile device running an application can receive an updated …

Modernizing The Microcontroller Laboratory With Low-Cost And Open-Source Tools, Kenneth J. Hass, Juliana Su

Faculty Conference Papers and Presentations

No abstract provided.