Open Access. Powered by Scholars. Published by Universities.®
Biomedical Engineering and Bioengineering Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Biomedical Engineering and Bioengineering
Optimization Of Wsu Total Ankle Replacement Systems, Bradley Jay Elliott
Optimization Of Wsu Total Ankle Replacement Systems, Bradley Jay Elliott
Browse all Theses and Dissertations
Total ankle arthroplasty (TAR) is performed in order to reduce the pain and loss of ambulation in patients with various forms of arthritis and trauma. Although replacement devices fail by a number of mechanisms, wear in the polyethylene liner constitutes one of the dominating failure modes. This leads to instability and loosening of the implant. Mechanisms that contribute to wear in the liners are high contact and subsurface stresses that break down the material over time. Therefore, it is important to understand the gait that generates these stresses. Methods to characterize and decrease wear in Ohio TARs have been performed …
Quantitative Computed-Tomography Based Bone-Strength Indicators For The Identification Of Low Bone-Strength Individuals In A Clinical Environment, Bino Abel Varghese
Quantitative Computed-Tomography Based Bone-Strength Indicators For The Identification Of Low Bone-Strength Individuals In A Clinical Environment, Bino Abel Varghese
Browse all Theses and Dissertations
The aim of the current study was to develop quantitative computed-tomography (QCT)-based bone-strength indicators that highly correlate with finite-element (FE)-based strength. We perform a combined numerical-experimental study, comparing FE-predicted surface strains with strain gauge measurements, to validate the FE models of 36 long bones (humerus, radius, femur and tibia) under three-point bending and torsion. The FE models were constructed from trans-axial volumetric CT scans, and the segmented bone images were corrected for partial-volume effects. The material properties (Young's modulus for cortex, density-modulus relationship for trabecular bone and Poisson's ratio) were calibrated by minimizing the error between experiments and simulations among …
Cervical Spine Biomechanical Behavior And Injury, Mbulelo T. Makola
Cervical Spine Biomechanical Behavior And Injury, Mbulelo T. Makola
Browse all Theses and Dissertations
A finite element model of the cervical spine including the C2 through C7 levels was developed in order to study the behavior of the cervical spine region. The model was validated in flexion extension, bending, and rotational load scenarios. The model was found to represent the biomechanical behavior of the cervical spine. The validated cervical spine finite element model was used to study spinal injury and disease processes. The model provided qualitative estimates of load carrying and stress distribution as well as range of motion.