Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Automotive Engineering
Reduced Exhaust Emissions Through Blending N-Butanol With Ultra Low Sulfur Diesel And Synthetic Paraffinic Kerosene In Reactivity Controlled Compression Ignition Combustion, Remi Gaubert
Electronic Theses and Dissertations
Increasing restrictions on the emitted exhaust emissions in diesel engines are becoming a more challenging task than in previous years. An electronic common rail fuel injection system and a port fuel injection (PFI) system were developed for an experimental engine to research dual fuel combustion. The experimental research was conducted at 1500 rpm and 4, 5, and 6 bar indicated mean effective pressure (IMEP). n-Butanol was port fuel injected at a 60% by mass fraction coupled with direct injection (DI) of three fuels, including ultra-low sulfur diesel (ULSD RCCI), a 50-50 wt-% blend of ULSD and butanol (ULSD-Bu RCCI), and …
Computational Fluid Dynamics Modeling Of The Effects Of Water Injection In A Diesel Engine, Rabun Z. Wallace
Computational Fluid Dynamics Modeling Of The Effects Of Water Injection In A Diesel Engine, Rabun Z. Wallace
Electronic Theses and Dissertations
Water injection has been used in internal combustion engines for many years. It has been used to cool combustion temperatures, reduce emissions, and in some instances clean carbon buildup from the cylinder. Research has shown that the water to fuel mass ratio is most effective between 20-30%, so the upper and lower limit were used for simulations in Converge CFD. To validate the CFD model, a case without water injection was compared to experimental data from Sandia National Laboratory. The predicted in-cylinder pressure and heat release rate showed good agreement with the experimental data. Cases were run with the injection …