Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 4 of 4
Full-Text Articles in Automotive Engineering
A Multi-Perspective Architecture Framework For Managing Multi-Fidelity Simulations Using Feature-Based Product Line Engineering, Ryan Colletti
A Multi-Perspective Architecture Framework For Managing Multi-Fidelity Simulations Using Feature-Based Product Line Engineering, Ryan Colletti
All Dissertations
This dissertation aims to facilitate the process for generating system-level simulations using new and existing product line engineering practices within a SysML reference architecture of the simulation domain. The modern passenger vehicle is becoming increasingly complex with the addition of more software-oriented features, especially Advanced Driver Assistance Systems (ADAS), leading to higher numbers of recalls. To mitigate this, the result of this research is the novel Vehicle Simulation Architecture Framework (VSAF). This dissertation presents the VSAF, its innovations, and a characterization of its scalability, applicability, and initial investment vs. incremental cost tradeoffs as compared to those of current simulation practices. …
Manufacturing A Composite Wheel Prototype Using 3d Printed Molds, Steven Thuening
Manufacturing A Composite Wheel Prototype Using 3d Printed Molds, Steven Thuening
All Graduate Theses, Dissertations, and Other Capstone Projects
Throughout the evolution of high performance racing, a large emphasis has been on reducing the weight of the vehicle in order to improve its performance. Over the years, new designs and materials have been introduced reducing weight in a variety of different locations. Comparing weight reduced in different areas has shown that some areas are more valuable to reduce than others are. Perhaps one of the most beneficial locations are the wheels. This is because the mass of the wheel is considered unsprung and rotational. Because of this, large improvements towards the reduction of wheel mass have been developed in …
The Effects Of Layer Thickness On Dry-Sliding Wear Of Binder Jet Additively Manufactured Stainless Steel And Bronze Composite, Cody Ingenthron
The Effects Of Layer Thickness On Dry-Sliding Wear Of Binder Jet Additively Manufactured Stainless Steel And Bronze Composite, Cody Ingenthron
All Graduate Theses, Dissertations, and Other Capstone Projects
Pin on disk wear testing was used to compare additively manufactured binder jet metal matrix composites. The process parameters were changed. The layer thickness and applied forces were varied for the experimental study. Three different layer thicknesses used were, 50μm, 100μm, and 200μm. The pin used was a 420 stainless pin. The wear characteristics of the disk were examined using pin-on-disc method. The material tested was a composite of 420 stainless steel, and 90-10 bronze. Samples were weighed before, during, and after the test to determine differences in mass. Wear tracks were examined using a Scanning Electron Microscope. The results …
The Effects Of Low-Level Ethanol Blends In 4-Stroke Small Non-Road Engines, Chris Reek
The Effects Of Low-Level Ethanol Blends In 4-Stroke Small Non-Road Engines, Chris Reek
All Graduate Theses, Dissertations, and Other Capstone Projects
Small Non-Road Engines (SNRE's) abound in numbers and are used daily by consumers and businesses alike. Considering the atmosphere of change looming in the air regarding alternative fuels, this particular engine classification will also be affected by any change in standardization of fuels. This body of research attempts to address possible ways SNRE's can change their operational characteristics after being fueled by specific yet differing fuels. These characteristics will be contrasted against blends of ethanol with gasoline, from 0% ethanol to 20% ethanol, run on test engines to determine patterns, if any, of these characteristics. Topics include: materials compatibility, engine …