Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Automotive Engineering
Manufacturing A Composite Wheel Prototype Using 3d Printed Molds, Steven Thuening
Manufacturing A Composite Wheel Prototype Using 3d Printed Molds, Steven Thuening
All Graduate Theses, Dissertations, and Other Capstone Projects
Throughout the evolution of high performance racing, a large emphasis has been on reducing the weight of the vehicle in order to improve its performance. Over the years, new designs and materials have been introduced reducing weight in a variety of different locations. Comparing weight reduced in different areas has shown that some areas are more valuable to reduce than others are. Perhaps one of the most beneficial locations are the wheels. This is because the mass of the wheel is considered unsprung and rotational. Because of this, large improvements towards the reduction of wheel mass have been developed in …
The Effects Of Layer Thickness On Dry-Sliding Wear Of Binder Jet Additively Manufactured Stainless Steel And Bronze Composite, Cody Ingenthron
The Effects Of Layer Thickness On Dry-Sliding Wear Of Binder Jet Additively Manufactured Stainless Steel And Bronze Composite, Cody Ingenthron
All Graduate Theses, Dissertations, and Other Capstone Projects
Pin on disk wear testing was used to compare additively manufactured binder jet metal matrix composites. The process parameters were changed. The layer thickness and applied forces were varied for the experimental study. Three different layer thicknesses used were, 50μm, 100μm, and 200μm. The pin used was a 420 stainless pin. The wear characteristics of the disk were examined using pin-on-disc method. The material tested was a composite of 420 stainless steel, and 90-10 bronze. Samples were weighed before, during, and after the test to determine differences in mass. Wear tracks were examined using a Scanning Electron Microscope. The results …