Automotive Engineering Commons^™

Radio Direction Finding Using Pseudo-Doppler For Uav-Based Animal Tracking, Anup Karki

Masters Theses

Radio Direction Finding (RDF) is commonly used for low cost tracking and navigation systems. However, for a low cost application and mobility, the design constraints are highly limited. Pseudo Doppler (PD) can improve RDF capabilities without being cost prohibitive. This work entails the analysis of PD RDF and its potential use for Unmanned Aerial Vehicles (UAV) that are currently employed in wildlife research animal tracking. PD is based on the doppler effect or doppler shift. The doppler effect works like a frequency modulator that increases or decreases the observed frequency depending on whether a signal source is approaching or receding …

Cfd Study Of Aerodynamic Drag Reduction Tool Of A Generic Sports Utility Vehicle (Suv), Samira Ishrat Jahan

Masters Theses

The Sports Utility Vehicle (SUV) has been a popular automobile choice in North America for over 50 years due to its seating and hauling versatility and good towing capacity. This widespread popularity has resulted in manufacturers pushing for increased horsepower and cabin size. Unfortunately, the limiting factor has been fuel economy which is governed by the vehicle aerodynamics. A reduction in aerodynamic drag can result in better fuel economy. The goal of this study is to reduce the aerodynamic drag of a generic SUV and the efficient application of drag reduction devices to control flow separation. An initial study has …

Study Of Cooling-Drag In A Generic Passenger Car Using Cfd And Wind Tunnel, Md Maruf Hossain

Masters Theses

The focus of the study is to explore aerodynamic aspects of cooling airflow. As a result of this study, an efficient multi-domain aero-thermal model was developed to analyze the cooling drag of a generic passenger vehicle. Cooling drag is described as the additional force that the production vehicle has to overcome while moving in comparison to the force if all the openings were closed. Though this model was developed based on the sedan class vehicle, the applied methodology could be generalized for other ground vehicle types. As a part of the presented model, a unique simplified geometric model is developed …

A Fea/Cfd Study Of Heat Transfer To Semi-Trailer Disc Brake Wheel-End Components During A Braking Event, Justin P. Fisher

Masters Theses

Foundation air disc brakes bring Class 8 semi-trailers to a stop by converting kinetic energy into thermal energy. Recently, side skirts have been added to the underside of semi-trailers to improve fuel economy. The reduction in airflow under the trailer they create has potential to increase brake temperatures by reducing convection heat transfer. This will require an increase in conduction and radiation heat transfer to the surrounding wheel-end parts. Additional heat transfer to the surrounding parts could increase the temperatures in the hub and bearing to damaging levels.

CFD analyses were developed to model the airflow under the semi-trailer with …

Modeling Of Optimized Neuro-Fuzzy Logic Based Active Vibration Control Method For Automotive Suspension, Mohammad Adom Safiullah

Masters Theses

In this thesis, an active vibration control system was developed. The control system was developed and tested using a quarter car model of an adaptive suspension system. For active vibration control, an actuator was implemented in addition to the commonly used passive spring damper system. Due to nature of unpredictability of force required two different fuzzy inference system (FIS) were developed for the actuator. First a sequential fuzzy set was built, that resulted lower vertical displacement compared to basic damper spring model, but system had limited effect with disturbances of higher magnitude and continuous vibrations (rough road). To improve the …