Automotive Engineering Commons^™

Spray And Combustion Studies Of High Reactivity Gasoline In Comparison To Diesel Under Advanced Compression Ignition Engine Conditions, Meng Tang

Dissertations, Master's Theses and Master's Reports

Gasoline compression ignition (GCI) technology has demonstrated great potentials in improving fuel economy and reducing engine-out NO_x and particulate matter emissions. Development and application of the GCI technology on multi-cylinder engines require both fundamental understandings of the gasoline spray combustion characteristics and accurate numerical tools. Due to the large differences in the thermo-physical and the chemical properties between gasoline and diesel range fuels, differences in the spray combustion characteristics between gasoline and diesel is expected. Reports on the gasoline spray combustion characteristics under conditions relevant to medium to heavy-duty engines are scarce and this dissertation aims to fill in …

The Interaction Of Ignition And In-Cylinder Flow On Flame Kernel Development And Its Impacts On Combustion In An Optically Accessible Direct Injection Engine, Yanyu Wang

Dissertations, Master's Theses and Master's Reports

A significant challenge facing spark-ignited (SI) engines to achieve higher efficiency via highly diluted combustion is the quickly increased combustion instability as the dilution level increases. The flow motion variation has been identified as a dominant factor that introduces combustion variability at highly diluted conditions. However, the detailed mechanism of how the variation in flow motion impacts the flame kernel development and introduces combustion instability is only partially understood. This research investigated the impacts of the in-cylinder flow on variability of the ignition and early flame kernel development in a single cylinder direct-injection spark-ignition (DI-SI) optically accessible engine and accessory …

Control Oriented Modeling Of An Automotive Drivetrain For Anti-Jerk Control, Gurijala Venkat Prithvi Reddy

Dissertations, Master's Theses and Master's Reports

Drivability is an important metric during the development of an automobile. Calibration engineers spend a significant amount of time trying to improve the drivability of vehicles for various driving conditions. With an increase in the available computational power in an automobile, novel model-based methods are being implemented for further improving the drivability, while reducing calibration time and effort. Phenomenon known as clunk and shuffle, which are caused due to backlash and compliance in the driveline, are a major cause of issues related to drivability and noise, vibration and harshness (NVH) during tip-in and tip-out scenarios.

This thesis focuses on developing …

Cold Start Analysis And Modeling Of A Direct-Injection Gasoline Engine, Yash Borghate

Dissertations, Master's Theses and Master's Reports

In this thesis, two different works related to cold start of a direct-injection (DI) gasoline engine are shown. First, effect of split injection is studied on engine exhaust temperature and hydrocarbon emissions for cold start conditions. Instead of single injection, two injections are done, one injection during the intake stroke and one injection during the compression stroke. Split injection is known to reduce jet wall wetting, thus reducing the hydrocarbon emissions from engine itself. Further, split injection reduces engine cycle-by-cycle variability with respect to the single injection case. Correlations between start of injection for the injection in the intake stroke …

Modeling And Analysis For Driveline Jerk Control, Prince Lakhani

Dissertations, Master's Theses and Master's Reports

In modern-day automotive industry, automotive manufacturers pay keen attention to driver’s safety and comfort by ensuring good vehicle drivability, feel of acceleration, limiting jerk and noise. The vehicle driveline plays a critical role to meet these criteria. By using high-fidelity simulation tool such as AMESim®, it is now possible to accurately model the vehicle driveline to be tested for different scenarios. With Simulink®, one can develop an efficient torque-based control system to limit the driveline oscillations and the generated noise. So, a joint simulation is used which provides a platform to evaluate the estimators and control system while considering the …