Engineering Commons^™

Standard Design For Nebraska County Bridges, Chungwook Sim, Jiong Hu, Maher K. Tadros, Alexander Bleyhl, David Gee

Nebraska Department of Transportation: Research Reports

Many county-owned bridges in Nebraska need replacement due to their structural deficiency. Most of the bridges needing replacement are in the 40 to 60 ft range. This span range lacks a standard design that fits Nebraska county practices in terms of speed and simplicity of construction. The current systems being used are (a) Precast 1 by 2 ft planks which can span up to 30 ft, (b) Cast-in-place slab bridges which can span up to 50 ft but require extensive field formwork, concrete placing, and curing, and are best when constructed in three-span units, and (c) Inverted tees which can …

Long-Term Performance Evaluation Of Nudeck In Kearney East Bypass, George Morcous, Marc Maguire

Nebraska Department of Transportation: Research Reports

The Kearney East Bypass bridge is the first project that implements the newly developed precast concrete deck system (known as 2nd generation NUDECK). The new system consists of full-depth full-width precast prestressed concrete deck panels that are 12 ft (3.66 m) long each. The panels have covered shear pockets at 4 ft (1.22 m) spacing on each girder line to host clustered shear connectors that are adjustable in height. Narrow unreinforced transverse joints are used to eliminate the need for deck overlay. Also, deck panels are post-tensioned in the longitudinal direction using a new post-tensioning system that eliminates the need …

Condition Assessment Of Bridge Decks With Asphalt Overlay, Sepehr Pashoutani, Jinying Zhu

Nebraska Department of Transportation: Research Reports

Ground penetrating RADAR (GPR) is a widely used nondestructive testing (NDT) method for bridge deck evaluation. However, the current GPR signal and data processing software and algorithms are not able to provide comprehensive information about bridge deck condition. Although the original objective of this research project was to develop GPR analysis algorithms for condition assessment of bridge decks with asphalt overlay, the scope of work has been expanded to concrete bridge decks with or without overlays.

In this study, the research team developed a complete GPR analysis procedure that includes the following components: 1) obtain zero-time for GPR reflection at …

Precast Concrete Deck-To-Girder Connection Using Uhpc, George Morcous, Mostafa Abo El-Khier

Nebraska Department of Transportation: Research Reports

The implementation of ultra-high-performance concrete (UHPC) in bridge construction has been growing rapidly in the last two decades due to its excellent mechanical properties, workability, and durability. This report presents a new UHPC connection between precast concrete deck panels and bridge girders that eliminates changes to the design and production of girder shear connectors commonly used in conventional cast-in-place concrete deck construction. In conventional construction, girder shear reinforcement or studs are extended into the cast-in-place concrete deck to transfer interface shear and create composite section. In the new connection, girder shear reinforcement or studs are kept underneath the deck panels, …

A Practitioner’S Guide To Small Unmanned Aerial Systems For Bridge Inspection, Sattar Dorafshan, Robert J. Thomas, Calvin Coopmans, Marc Maguire

Electrical and Computer Engineering Faculty Publications

Small unmanned aerial system(s) (sUAS) are rapidly emerging as a practical means of performing bridge inspections. Under the right condition, sUAS assisted inspections can be safer, faster, and less costly than manned inspections. Many Departments of Transportation in the United States are in the early stages of adopting this emerging technology. However, definitive guidelines for the selection of equipment for various types of bridge inspections or for the possible challenges during sUAS assisted inspections are absent. Given the large investments of time and capital associated with deploying a sUAS assisted bridge inspection program, a synthesis of authors experiences will be …

Uhpc Shear Keys In Concrete Bridge Superstructures, Craig Newtson, Brad Weldon, Elsy Flores, Jordan Varbel, William Toledo

Data

Corresponding data set for Tran-SET Project No. 18CNMS01. Abstract of the final report is stated below for reference:

"This research investigated the use of locally produced ultra-high performance concrete (UHPC) as a grouting material to repair deteriorated shear keys. Shear keys are used in adjacent girder superstructures to produce monolithic behavior and load transfer across the structure. Shear key durability is a concern since shear key degradation can jeopardize the integrity of the structure. Transportation agencies have reported that 75% of distress in adjacent girder bridges is due to cracking and de-bonding along shear keys. Previous research has shown that …

Structural Vulnerability Of Coastal Bridges Under Extreme Hurricane Conditions, Arturo Montoya, Adolfo Matamoros, Firat Testik, Reza Nasouri, Adnan Shahriar, Arsalan Majlesi

Data

Corresponding data set for Tran-SET Project No. 18STTSA04. Abstract of the final report is stated below for reference:

"This work presents the results of a numerical study evaluating the response of coastal bridges due to hurricane-induced waves. The analyses were conducted using the Coupled Eulerian-Lagrangian (CEL) approach, available on the commercial finite element software Abaqus, which allows modeling the interaction between water and the bridge. The work concentrated on (1) establishing an approach for modeling the desired wave characteristics (i.e., wave height, and frequency) within the CEL simulation, (2) conducting simulations using actual bridge dimensions of historically damaged bridges, (3) …

Uhpc Shear Keys In Concrete Bridge Superstructures, Craig Newtson, Brad Weldon, Elsy Flores, Jordan Varbel, William Toledo

Publications

This research investigated the use of locally produced ultra-high performance concrete (UHPC) as a grouting material to repair deteriorated shear keys. Shear keys are used in adjacent girder superstructures to produce monolithic behavior and load transfer across the structure. Shear key durability is a concern since shear key degradation can jeopardize the integrity of the structure. Transportation agencies have reported that 75% of distress in adjacent girder bridges is due to cracking and de-bonding along shear keys. Previous research has shown that locally produced UHPC has excellent mechanical and durability properties. UHPC has also been shown to have good bonding …

Structural Vulnerability Of Coastal Bridges Under Extreme Hurricane Conditions, Arturo Montoya, Adolfo Matamoros, Firat Testik, Reza Nasouri, Adnan Shahriar, Arsalan Majlesi

Publications

This work presents the results of a numerical study evaluating the response of coastal bridges due to hurricane-induced waves. The analyses were conducted using the Coupled Eulerian-Lagrangian (CEL) approach, available on the commercial finite element software Abaqus, which allows modeling the interaction between water and the bridge. The work concentrated on (1) establishing an approach for modeling the desired wave characteristics (i.e., wave height, and frequency) within the CEL simulation, (2) conducting simulations using actual bridge dimensions of historically damaged bridges, (3) analyzing a range of foundation flexibilities to determine its effect on the uplift and shear forces acting on …

Performance Evaluation Of Inverted Tee (It) Bridge System, Garrett P. Martindale, Daniel Watson, Antony Mohsen Kamal Masoud Kodsy, Mostafa Abo El-Khier, Richard L. Wood, George Morcous

Nebraska Department of Transportation: Research Reports

The Inverted Tee (IT) girder bridge system was originally developed in 1996 by the University of Nebraska–Lincoln (UNL) researchers and Nebraska Department of Transportation (NDOT) engineers. This bridge system currently accounts for over 110 bridges in Nebraska used for both state highways and local county roads. Extensive longitudinal and transverse deck cracking have been observed and noted in numerous bridge inspection reports. Since the IT girder bridge system is relatively new, limited data and knowledge exist on its structural performance and behavior. This study evaluates the IT girder bridge system by conducting twenty field observations as well as recording accelerometer, …

Pedestrian Bridge In Tanzania, Maja Sagaser, Karina Rosales

Architectural Engineering

This senior project originated to address the need of the community of Same, Tanzania. There is a deep and wide ravine which floods, making the path many adults and children take to the Majevu Primary School increasingly difficult and dangerous. This report encapsulates all of the steps taken to complete an approved final design for a footbridge to be constructed over this ravine. It includes the project overview, the architectural and structural design process, as well as the important considerations. There are also structural drawings that include plans, elevations, and details.

2019 Student Steel Bridge Team, Kourtney Arena, Andrew Biglin, Brett Palmer, Nathaniel Maute, Kenneth Reiser, Jacob Dicks, Paul Kowaleski

STEM Student Research Symposium Posters

Every year AISC runs a regional and national steel bridge competition. The competition offers a chance for civil engineering students to gain valuable experience designing a bridge. In addition to this, mechanical engineering students are provided the opportunity to practice machining steel parts. For the competition, teams from participating schools are given a scenario with certain constraints to design a bridge for. At the competition, the bridges are ranked based on weight, structural efficiency, construction economy, assembly speed, deflection, aesthetics, and overall performance.

The program Risa 3D was used in order to design and perform analysis on the bridge. Using …

Save Our Sound Obx, Inc. V. North Carolina Department Of Transportation, Mitch L. Werbell V

Public Land & Resources Law Review

The Fourth Circuit Court of Appeals recently ruled in favor of several governmental agencies seeking to construct a new bridge in the Pamlico Sound adjacent to North Carolina’s Outer Banks. For years, state and federal agencies have put forth a massive coordinated effort to address the constant weather damage and erosion which occurs to a section of North Carolina Highway 12. The court found the agencies properly cleared NEPA’s environmental review requirements for the bridge’s construction. Additionally, the opponent-litigants’ efforts to add claims challenging the project, based on new information about a shipwreck in the bridge’s path, were futile.

Retrofitting Of Bridge Elements Subjected To Predominantly Axial Load Using Uhpc Shell, Mahsa Farzad

FIU Electronic Theses and Dissertations

In the United States, ~30% of the ~600,000 highway bridges are categorized as structurally deficient or functionally obsolete. These bridges should be replaced or upgraded to sustain the transportation needs of the growing public and private sectors of the U.S. economy. It is not uncommon for structures to have advanced levels of corrosion-induced damage where major repair and maintenance works are required. However, the transportation infrastructure may undergo disruption during rehabilitation causing interruption to critical economic public, civil and commercial activities. This mandates the development of new techniques and materials for accelerated rehabilitation and resilience. To address this issue, a …

Towards Multiple Model Approach To Bridge Deterioration, Jin A. Collins

Open Access Theses & Dissertations

The Intermodal Surface Transportation Efficiency Act of 1991 (ISTEA) marked the start of a new era in transportation in the United States. ISTEA required transportation agencies to take a proactive approach to planning and management of their assets. This included requirements for managing pavement, bridges, safety, congestion, public transportation, and intermodal systems. For horizontal transportation assets (i.e., bridges and pavement), deterioration modeling is an essential tool (Yanev and Chen 1993). Since ISTEA, Bridge Management Systems (BMS) have been utilized to inform decision-making regarding bridge projects such as maintenance, rehabilitation, and replacement (MR&R) under financial limitations (Agrawal, Kawaguchi, and Chen 2010). …

Load Rating Mobility As A Framework For Bridge Owners, Bryan Keith Stephens

Open Access Theses & Dissertations

In this time of financial economy, bridge owners are faced with the important decision of where to focus financial assets while attempting to determine which structures are in most need. Bridge Engineers and researchers alike agree that a large portion of the United States bridge population are reaching the end of their design life. Researchers are currently investigating various means and methods of lengthening the amount of usefulness of these key pieces of infrastructure. This paper introduces the novel idea of bridge Load Rating Mobility and how it can be leveraged by stake holders to assist in making those financial …

Shear Stress Estimates In The Approach And Bridge Section By Using Various Formula, Jun Seon Lee

Graduate Theses, Dissertations, and Problem Reports

Shear stress is the resistance force on top of the contact surface caused by moving flow and is one of the important variable in fluid mechanics. Thus, a lot of researches have been conducted to predict accurate value of shear stress. However, calculating shear stress with existing equations has several limitations because only gradually varied flow and/or uniform flow was considered in their studies. Therefore, direct applying those methods into complex flow type, such as around a bridge, to predict shear stress is questionable.

Thus, laboratory experiments were carried out in a laboratory flume to attack the objective of this …

Unmanned Aerial And Traversing Vehicle -- A Mobile Platform For Bridge Inspections, Clayton A. Fritsche

Masters Theses

“Unmanned aerial vehicles (UAVs), also known as drones, have been rapidly growing in popularity since their creation. This study aimed to create a robotic platform used to assist in the inspection process of the nation’s aging and deteriorating bridges. To this end, a multimodal inspection robot that utilized both flying and driving technologies, was designed, analyzed, and tested for aerial, traversing, and their transitional operability. The design, herein referred to as the “BridgeBot”, was evaluated both computationally and experimentally. A finite element model of the BridgeBot was established and analyzed under static loading scenarios to help determine stress distributions and …