Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Institution
- Publication Type
Articles 1 - 7 of 7
Full-Text Articles in Engineering
Surface Raman Spectra Obtained From Various Electrodeposited Transidon Metals, Jingsong Gao, Bin Ren, Qunjian Huang, Zhongqun Tian
Surface Raman Spectra Obtained From Various Electrodeposited Transidon Metals, Jingsong Gao, Bin Ren, Qunjian Huang, Zhongqun Tian
Journal of Electrochemistry
Good quality potential-dependent surface Raman spectra of pyridine were obtained for the first time from a series of transition metals,e. g.,Fe,Co,Ni,Ru,Rh,Pd and Pt,which were electrodeposited on non-SERS-active substrates.The influences of the applied potential and the nature of metal on the adsorption behaviors were discussed briefly.This result illustrates that Raman spectroscopy is becoming a more general and powerful tool to study various electrochemical interfaces.
In Situ Studies Of Copper Electrodepostion On Hopg By Using Ecstm, Zhaoxiong Xie, Bingwei Mao, Xiangdong Zhuo, Jiqian Mu, Zhaowu Tian
In Situ Studies Of Copper Electrodepostion On Hopg By Using Ecstm, Zhaoxiong Xie, Bingwei Mao, Xiangdong Zhuo, Jiqian Mu, Zhaowu Tian
Journal of Electrochemistry
In this paper, copper electrodepostion on HOPG had been in situ studied by using a homebuilt electrochemical scanning tunneling microscopy (ECSTM). Three dimensional nucleation and subsequent growth of copper crystals were found as the initial stage of copper deposition on HOPG. In the case of lower overpotential or lower concentration of Cu 2+ , the bulk deposited copper layer tended to form smooth terraces, and grow at the edge of steps. The terraces were stable to some extent, which made it possible to be observed with atomic resolution. At a higher overpotential, the crystal size of copper were somehow smaller. …
Preparation Techique Of Foamed Nickel By Electrodeposition, Xihua He, Ronghui Hu, Hanxi Yang, Zhengzhong Zuo
Preparation Techique Of Foamed Nickel By Electrodeposition, Xihua He, Ronghui Hu, Hanxi Yang, Zhengzhong Zuo
Journal of Electrochemistry
This paper describes the preparation technique and operation conditions for manufacturing foamed nickel by chemilcal pretreament, electrodeposition and heat treatment. The foamed nickel made in this method showed high porosity, uniformity and considerable strength and tenacity,applicable for various secondary battery electrodes.
Xrd, Xps And Sims Investigations On Electrodeposited Nickel-Phosphorous Alloy Coatings
Xrd, Xps And Sims Investigations On Electrodeposited Nickel-Phosphorous Alloy Coatings
A.S. Md Abdul Haseeb
Structural and chemical investigations on electrodeposited nickel-phosphorous alloy coatings by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and secondary ion mass spectroscopy (SIMS) are described. Electrodeposition of nickel-phosphorous coatings has been carried out galvanostatically in a hypophosphite bath at two different current densities, namely 20 and 80 mA cm -2. XRD has shown a broad peak indicating an amorphous structure in both cases. XPS shows the presence of Ni 2P compound. XPS also reveals the amount of phosphorous in both coatings to be around 10.20 wt.%. SIMS has shown that the coating deposited at lower current density (20 mA cm …
A Model For The Galvanostatic Deposition Of Nickel Hydroxide, Mahesh Murthy, Gowri S. Nagarajan, John W. Weidner, John W. Van Zee
A Model For The Galvanostatic Deposition Of Nickel Hydroxide, Mahesh Murthy, Gowri S. Nagarajan, John W. Weidner, John W. Van Zee
Faculty Publications
A mathematical model is presented for the galvanostatic deposition of Ni(OH)2 films in stagnant Ni(NO3)2 solutions. The objective is to quantify the anomalous deposition behavior reported previously in which the utilization of the electrochemically generated OH– species decreased drastically as the concentration of Ni(NO3)2 increased beyond 0.1 M. For example as the Ni(NO3)2 concentration increased from 0.1 to 2.0 M, the deposition rate decreased by a factor of ten at 2.5 mA/cm2. At this high ratio of concentration to current density, a comparison with Faraday's …
Linear Algebra Used To Determine Independent Half‐Cell Equations, D. H. Coleman, Ralph E. White
Linear Algebra Used To Determine Independent Half‐Cell Equations, D. H. Coleman, Ralph E. White
Faculty Publications
No abstract provided.
Anomalous Codeposition Of Fe-Ni Alloys And Fe-Ni-Sio2 Composites Under Potentiostatic Conditions, M. Ramasubramanian, S. N. Popova, Branko N. Popov, Ralph E. White, K. M. Yin
Anomalous Codeposition Of Fe-Ni Alloys And Fe-Ni-Sio2 Composites Under Potentiostatic Conditions, M. Ramasubramanian, S. N. Popova, Branko N. Popov, Ralph E. White, K. M. Yin
Faculty Publications
A mathematical model has been developed to describe the electrodeposition of Fe-Ni alloys and Fe-Ni-SiO2 composites under potentiostatic conditions. This model can be used to predict the polarization behavior, partial current densities, and alloy composition of each of the components as a function of the applied potential. Fe-Ni-SiO2 samples were deposited on platinum rotating disk electrodes from sulfate electrolytes under potentiostatic conditions, and the results obtained were compared to the model. The model predictions were found to agree well with the experimental observations for the Fe-Ni and Fe-Ni-SiO2 systems.