Engineering Commons^™

Dynamical Studies Of Model Membrane And Cellular Response To Nanosecond, High-Intensity Pulsed Electric Fields, Qin Hu

Electrical & Computer Engineering Theses & Dissertations

The dynamics of electroporation of biological cells subjected to nanosecond, high intensity pulses are studied based on a coupled scheme involving the current continuity and Smoluchowski equations. The improved pore formation energy model includes a dependence on pore population and density. It also allows for variable surface tension and incorporates the effects of finite conductivity on the electrostatic correction term, which was not considered by the simple energy models in the literature. It is shown that E(r) becomes self-adjusting with variations in its magnitude and profile. The whole scheme is self-consistent and dynamic.

An electromechanical analysis based on thin-shell theory …

Design And Simulation Of An Induction Skull Melting System, Taide Tan

UNLV Theses, Dissertations, Professional Papers, and Capstones

Incorporating volatile actinides, mainly americium into a metallic fuel pin (MFP) has been a serious problem due to americium’s high vapor pressure. An Induction Skull Melting (ISM) system was identified by Argonne National Laboratory (ANL) as a potential furnace design to cast MFPs. Through the development of the ISM system, the nuclear waste feedstock can be melted and injected into the mold for fabricating MFPs in the advanced nuclear fuel cycles. The main phenomena in this system include: induction melting process, casting process and mass transfer process of americium. Issues related to ISM system design for casting MFPs are discussed …

Scaling And Characterization Of Direct Current Glow Discharge Plasma In Atmospheric Air, Abdel-Aleam Hefney Mohamed

Electrical & Computer Engineering Theses & Dissertations

A microhollow cathode discharge was used as a plasma cathode to sustain a stable direct current glow discharge in atmospheric pressure air. The volumetric scale of glow discharge increased from the millimeter to the centimeter range by extending the plasma in lateral and axial directions. In the axial direction, the length of the glow discharge column was varied from 1 mm to 2 cm, with the sustaining voltage increasing linearly with the glow discharge column length. Extension in the lateral direction was obtained by operating discharges in parallel. The glow discharge plasma of the parallel discharge columns was found to …

Microdischarge Arrays, Wenhui Shi

Electrical & Computer Engineering Theses & Dissertations

Microhollow cathode discharges (MHCDs) are DC or pulsed gas discharges between two electrodes, separated by a dielectric, and containing a concentric hole. The diameter of the hole, in this hollow cathode configuration, is in the hundred-micrometer range. MHCDs satisfy the two conditions necessary for an efficient excimer radiation sources: (1) high energy electrons which are required to provide a high concentration of excited or ionized rare gas atoms; (2) high pressure operation which favors excimer formation (a three-body process). Flat panel excimer sources require parallel operation of MHCDs. Based on the current-voltage characteristics of MHCD discharges, which have positive slopes …

Deviation Of Time-Resolved Luminescence Dynamics In Mwir Semiconductor Materials From Carrier Recombination Theory Predictions, Peter M. Johnson

Theses and Dissertations

Time resolved luminescence spectroscopy was used to characterize luminescence decay curves for a bulk InAs sample and an InAsSb type-I quantum-well sample over the first 3ns following excitation. The luminescence decay curves were then converted to carrier densities and used to find recombination coefficients that provided the least-squared-error solution of the rate equation describing carrier recombination. Recombination coefficients describing Shockley Read-Hall (A_SRH) radiative (B_rad) and Auger (C_Aug) recombination were determined at two different temperatures and four excitation powers, then analyzed for consistency and physical significance. For all of the resulting least …

Optical Characterization And Modeling Of Compositionally Matched Indium Arsenide-Antimonide Bulk And Multiple Quantum Well Semiconductors, Scott C. Phillips

Theses and Dissertations

Indium arsenide-antimonide (InAsSb) semiconductors have been determined to emit in the 3-5 micrometer range, the window of interest for countermeasures against infrared electro-optical threats. This experiment set out to cross the bulk to quantum well characterization barrier by optically characterizing two sets of compositionally matched type I quantum well and bulk well material samples. Absorption measurements determined the band gap energy of the bulk samples and the first allowed subband transition for the quantum wells. By collecting absorption spectra at different temperatures, the trend of the energy transitions was described by fitting a Varshni equation to them. The expected result …

A Rapidly-Converging Alternative To Source Iteration For Solving The Discrete Ordinates Radiation Transport Equations In Slab Geometry, Nicholas J. Wager

Theses and Dissertations

I present a numerical technique to solve the time independent Boltzmann Transport Equation for the transport of neutrons and photons. The technique efficiently solves the discrete ordinates equations with a new iteration scheme. I call this new scheme the angle space distribution iteration method because it combines a non-linear, high angular-resolution flux approximation within individual spatial cells with a coarse angular-resolution flux approximation that couples all cells in a spatial mesh. This shown to be an efficient alternative to source iteration. The new method is implemented using the step characteristic and exponential characteristic spatial quadrature schemes. The latter was introduced …

Multiple Scattering Of Light In Inhomogeneous Media And Applications, Claudia Mujat

Electronic Theses and Dissertations

Light scattering-based techniques are being developed for non-invasive diagnostics of inhomogeneous media in various fields, such as medicine, biology, and material characterization. However, as most media of interest are highly scattering and have a complex structure, it is difficult to obtain a full analytical solution of the scattering problem without introducing approximations and assumptions about the properties of the system under consideration. Moreover, most of the previous studies deal with idealized scattering situations, rarely encountered in practice. This dissertation provides new analytical, numerical, and experimental solutions to describe subtle effects introduced by the properties of the light sources, and by …

Polarimetric Characterization Of Random Electromagnetic Beams And Applications, Mircea Mujat

Electronic Theses and Dissertations

Polarimetry is one of the principal means of investigating the interaction of light with matter. Theoretical models and experimental techniques are presented in this dissertation for polarimetric characterization of random electromagnetic beams and of signatures of random media in different scattering regimes and configurations. The degree of polarization rather than the full description of the state of polarization is of interest in multiple scattering and free space propagation where the statistical nature and not the deterministic component of light bears the relevant information. A new interferometric technique for determining the degree of polarization by measuring the intensity fluctuations in a …

Quadratic Spatial Soliton Interactions, Ladislav Jankovic

Electronic Theses and Dissertations

Quadratic spatial soliton interactions were investigated in this Dissertation. The first part deals with characterizing the principal features of multi-soliton generation and soliton self-reflection. The second deals with two beam processes leading to soliton interactions and collisions. These subjects were investigated both theoretically and experimentally. The experiments were performed by using potassium niobate (KNBO3) and periodically poled potassium titanyl phosphate (KTP) crystals. These particular crystals were desirable for these experiments because of their large nonlinear coefficients and, more importantly, because the experiments could be performed under non-critical-phase-matching (NCPM) conditions. The single soliton generation measurements, performed on KNBO3 by launching the …

Stable Spatial Solitons In Semiconductor Optical Amplifiers, Erdem Ultanir

Electronic Theses and Dissertations

A spatial soliton is a shape invariant self guided beam of light or a self induced waveguide. Spatial solitons appear as a result of the balance of diffraction and nonlinear focusing in a system. They have been observed in many different conservative media in the last couple of years. Solitons are ubiquitous, because of the probability of using their interactions in optical data processing, communications etc. Up to now due to the power required to generate the solitons, and the response times of the soliton supporting media, these special waves of nature could not penetrate the applications arena. Semiconductors, with …

Chemical Structure - Nonlinear Optical Property Relationships For A Series Of Two-Photon Absorbing Fluorene Molecules, Joel Mccajah Hales

Electronic Theses and Dissertations

This dissertation reports on the investigation of two-photon absorption (2PA) in a series of fluorenyl molecules. Several current and emerging technologies exploit this optical nonlinearity including two-photon fluorescence imaging, three-dimensional microfabrication, site-specific photodynamic cancer therapy and biological caging studies. The two key features of this nonlinearity which make it an ideal candidate for the above applications are its quadratic dependence on the incident irradiance and the improved penetration into absorbing media that it affords. As a consequence of the burgeoning field which exploits 2PA, it is a goal to find materials that exhibit strong two-photon absorbing capabilities. Organic materials are …

Thermal Management, Beam Control,And Packaging Designs For High Power, Te-Yuan Chung

Electronic Theses and Dissertations

Several novel techniques for controlling, managing and utilizing high power diode lasers are described. Low pressure water spray cooling for a high heat flux system is developed and proven to be an ideal cooling method for high power diode laser arrays. In order to enable better thermal and optical performance of diode laser arrays, a new and simple optical element, the beam control prism, is invented. It provides the ability to accomplish beam shaping and beam tilting at the same time. Several low thermal resistance diode packaging designs using beam control prisms are proposed, studied and produced. Two pump cavity …

Evaluation Of The Photo-Induced Structural Mechanisms In Chalcogenide, Cedric Lopez

Electronic Theses and Dissertations

Chalcogenide glasses and their use in a wide range of optical, electronic and memory applications, has created a need for a more thorough understanding of material property variation as a function of composition and in geometries representative of actual devices. This study evaluates compositional dependencies and photo-induced structural mechanisms in As-S-Se chalcogenide glasses. An effective fabrication method for the reproducible processing of bulk chalcogenide materials has been demonstrated and an array of tools developed, for the systematic characterization of the resulting material's physical and optical properties. The influence of compositional variation on the physical properties of 13 glasses within the …

Selective Mode Excitation In Specialty Waveguides Using Micro Optical, Waleed Mohammed

Electronic Theses and Dissertations

Although optical fibers and specialty waveguides are the base of majority of today's telecom and light delivery applications, fabrication deformation, nonlinearity and attenuation limit the bandwidth of the data being transmitted or the amount of power carried by these systems. One-way to overcome these limitations without changing the fibers design or fabrication is to engineer the input light in order to excite a certain mode or a group of modes with unique optical properties. Diffractive and micro optics are highly effective for selectively coupling light to specific modes. Using micro optics, mode selective coupling can be achieved through several matching …

Discrete Nonlinear Wave Propagation In Kerr Nonlinear Media, Joachim Meier

Electronic Theses and Dissertations

Discrete optical systems are a subgroup of periodic structures in which the evolution of a continuous electromagnetic field can be described by a discrete model. In this model, the total field is the sum of localized, discrete modes. Weakly coupled arrays of single mode channel waveguides have been known to fall into this class of systems since the late 1960's. Nonlinear discrete optics has received a considerable amount of interest in the last few years, triggered by the experimental realization of discrete solitons in a Kerr nonlinear AlGaAs waveguide array by H. Eisenberg and coworkers in 1998. In this work …

Dispersion-Managed Breathing-Mode Semiconductor Mode-Locked Ring Laser, Bojan Resan

Electronic Theses and Dissertations

A novel dispersion-managed breathing-mode semiconductor mode-locked ring laser is developed. The "breathing-mode" designation derives from the fact that intracavity pulses are alternately stretched and compressed as they circulate around the ring resonator. The pulses are stretched before entering the semiconductor gain medium to minimize the detrimental strong integrating self-phase modulation and to enable efficient pulse amplification. Subsequently compressed pulses facilitate bleaching the semiconductor saturable absorber. The intracavity pulse compression ratio is higher than 50. Down chirping when compared to up chirping allows broader mode-locked spectra and shorter pulse generation owing to temporal and spectral semiconductor gain dynamics. Pulses as short …

Monolithic Integration Of Dual Optical Elements On High Power Semicond, Laurent Vaissie

Electronic Theses and Dissertations

This dissertation investigates the monolithic integration of dual optical elements on high power semiconductor lasers for emission around 980nm wavelength. In the proposed configuration, light is coupled out of the AlGaAs/GaAs waveguide by a low reflectivity grating coupler towards the substrate where a second monolithic optical element is integrated to improve the device performance or functionality. A fabrication process based on electron beam lithography and plasma etching was developed to control the grating coupler duty cycle and shape. The near-field intensity profile outcoupled by the grating is modeled using a combination of finite-difference time domain (FDTD) analysis of the nonuniform …

Towards Direct Writing Of 3-D Photonic Circuits Using Ultrafast Lasers, Arnaud Zoubir

Electronic Theses and Dissertations

The advent of ultrafast lasers has enabled micromachining schemes that cannot be achieved by other current techniques. Laser direct writing has emerged as one of the possible routes for fabrication of optical waveguides in transparent materials. In this thesis, the advantages and limitations of this technique are explored. Two extended-cavity ultrafast lasers were built and characterized as the laser sources for this study, with improved performance over existing systems. Waveguides are fabricated in oxide glass, chalcogenide glass, and polymers, these being the three major classes of materials for the telecommunication industry. Standard waveguide metrology is performed on the fabricated waveguides, …

Solid State Nmr Characterization Of Conductive Polyanilines, Yanina Anatolievna Goddard

Dissertations, Theses, and Masters Projects

Different forms of ring deuterated polyaniline with different conductivity have been characterized by solid state deuteron nuclear magnetic resonance.;Quadrupole echo (QE) spectra of all forms of polyaniline consist of a superposition of lineshapes for nearly rigid aromatic rings and a small fraction of rings which undergo fast 180?? flips. The intensity of the fast flipping component is temperature dependent and different for conductive emeraldine salt (ES) and non-conductive emeraldine base (EB). This is a manifestation of the different structure and morphology of these polymers.;Simultaneous measurements of QE lineshapes and the relaxation time anisotropies allowed an accurate description of motion in …

Dual Energy Scanning Beam X -Radiography, Randolph Frank Wojcik

Dissertations, Theses, and Masters Projects

Dual energy X-radiography is a method first developed in the mid-1970's by which one uses the information contained in the energy spectrum of the transmitted X-ray flux through an object. With this information one can distinguish the types of materials present in a radiograph and thus allow a computer to subtract them from the image enhancing the contrast of the remaining materials. Using this method, one can see details, which would have been hidden by overlying structures of other materials such as seen in radiographs of parts, made up of mixtures of metals and composites. There is also great interest …