Engineering Commons^™

Direct Sheet Molding Compound Process (D-Smc), Atieh Motaghi

Electronic Thesis and Dissertation Repository

The combination of highly crosslinked resin and long glass fiber reinforcement in direct sheet molding compound (D-SMC) provides the parts with high physical properties and low density suitable for large interior and exterior automotive applications. Different stages of D-SMC process including maturation zone and compression molding are studied using mathematical analysis, numerical simulation and experimental investigations.

An analytical analysis is used to calculate the pressure and velocity in the first section of maturation zone and then the permeability of fiber bundle is calculated by simulation and the agreement between the available empirical equation and simulation was obtained. The flow is …

Investigation And Modeling Of Dip-Coating Process For Dispersions, Mahyar Javidi Soufiani

Electronic Thesis and Dissertation Repository

Dip coating of liquid film deposition on cylindrical substrates is studied using mathematical modeling, numerical simulation and experimental investigation. A mathematical model based on the Landau-Levich approach for dip coating has been developed using the Ellis constitutive equation, for cylindrical geometries, to analyze the effects on the coating thickness of the substrate radius and hydrodynamic behavior for a non-Newtonian fluid. The influence of the viscosity at low shear rates near the surface of the withdrawal film is included in the Ellis model and coating thickness results for Ellis, power law and Newtonian models are compared with experimental data. Good agreement …