Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Theses/Dissertations

Mechanical Engineering

Spectral method

Articles 1 - 4 of 4

Full-Text Articles in Engineering

Spectrally-Accurate Algorithm For Flows In 3-Dimensional Rough Channels, Md Nazmus Sakib Dec 2015

Spectrally-Accurate Algorithm For Flows In 3-Dimensional Rough Channels, Md Nazmus Sakib

Electronic Thesis and Dissertation Repository

In this work a spectrally accurate algorithm has been developed for the simulation of three-dimensional flows bounded by rough walls. The algorithm is based on the velocity-vorticity formulation and uses the concept of Immersed Boundary Conditions (IBC) for the enforcement of the boundary conditions. The flow domain is immersed inside a fixed computational domain. The geometry of the boundaries is expressed in terms of double Fourier expansions and boundary conditions enter the algorithm in the form of constraints. The spatial discretization uses Fourier expansions in the stream-wise and span-wise directions and Chebyshev expansions in the wall-normal direction. The algorithm can …


Thermal Convection In Non-Fourier Fluids And Application To Liquid Helium Ii, Mohammad Niknami Esfahani Jan 2015

Thermal Convection In Non-Fourier Fluids And Application To Liquid Helium Ii, Mohammad Niknami Esfahani

Electronic Thesis and Dissertation Repository

This thesis examines different conditions for which non-Fourier effects can be significant in the flow of fluids. Non-Fourier fluids of dual-phase-lagging type (DPL) possess a relaxation time and a retardation time, reflecting the delay in the response of the heat flux and the temperature gradient with respect to one another. For non-Fourier fluids of single-phase-lagging type (SPL) the retardation time is zero. Non-Fourier fluids span a wide range of applications, including liquid helium, nanofluids and rarefied gases. The parallels between non-Fourier fluids and polymeric solutions are established.

The instability of steady natural convection of a thin layer of non-Fourier fluid …


Analysis And Optimization Of Film Cooling Effectiveness, Hessam Babaee Jan 2013

Analysis And Optimization Of Film Cooling Effectiveness, Hessam Babaee

LSU Doctoral Dissertations

In the first part, an optimization strategy is described that combines high-fidelity simu- lations with response surface construction, and is applied to pulsed film cooling for turbine blades. The response surface is constructed for the film cooling effectiveness as a function of duty cycle, in the range of DC between 0.05 and 1, and pulsation frequency St in the range of 0.2-2, using a pseudo-spectral projection method. The jet is fully modulated and the blowing ratio, when the jet is on, is 1.5 in all cases. Overall 73 direct numerical sim- ulations (DNS) using spectral element method were performed to …


Improved Non-Linear Solution Of Dip Coating Flow, Omar Bin Yusuf Aug 2012

Improved Non-Linear Solution Of Dip Coating Flow, Omar Bin Yusuf

Electronic Thesis and Dissertation Repository

A thin layer of film is developed on the surface of a substrate in the dip coating process where the substrate is initially immersed into the coating fluid and then withdrawn continuously from the coating fluid bath. In this study a two dimensional flow of the thin film for a Newtonian fluid is examined theoretically by dividing the film into three separate regions. A general formulation is developed for a thin film flow, which then simplifies for each region upon considering appropriate assumptions to each region. The influence of inertia and surface tension in the presence of gravity is investigated …