Engineering Commons^™

Colloidal Silica: Cement Enhancing Admixture Product Evaluation, Lieska Halsey, David Hansen

Nebraska Department of Transportation: Research Reports

As Class F- fly ash (F-ash) becomes scarce, PCC engineers will look to other supplemental cementitious materials (SCM) to replace F-ash and its ASR mitigating properties. Colloidal silica (CS), or nano-silica, has been shown to mitigate ASR at certain replacement levels; however, CS cannot be a full replacement of F-ash. Engineers at the Nebraska Department of Transportation (NDOT) learned of CS from a presentation given by Intelligent Concrete, Inc. at the 2019 Nebraska Concrete Professionals Association Conference and decided to investigate the potential use of CS in NDOT concrete mix designs.

Application Of Internal Curing To Improve Concrete Bridge Deck Performance, Arman Abdigaliyev, Yong-Rak Kim, Jiong Hu

Nebraska Department of Transportation: Research Reports

Due to the relatively high cement content and low water-to-cement ratio (w/c) used, bridge deck concrete is prone to premature cracking. Internal curing has been found to greatly reduce the chance of premature cracking as well as concrete deterioration. This research project was intended to develop internally cured bridge deck concrete based on a local mix design in Nebraska. Four different lightweight fine aggregate (LWFA) as internal curing agents were evaluated, and their effects on fresh, mechanical, durability, and shrinkage properties of concrete were studied. To identify the most effective LWFA dosage for shrinkage reduction, different replacement rates of sand …

Evaluation Of Tie-Bar Anchoring Methods: Non-Shrink Grout Vs. Epoxy, Wally Heyen, Lieska Halsey, Tim Krason, Brandon Varilek, David Hansen

Nebraska Department of Transportation: Research Reports

Tie bars are epoxy coated steel bars that connect the longitudinal joints in concrete pavement. Tie bars prevent faulting and joint separation between lanes Tie bars can be placed into the plastic concrete or inserted after curing by drilling and anchoring with epoxy or non-shrink grout. The specification for the tie bars requires the use of a No. 5 bar, 18 inches long and shall meet ASTM A775 / A775M [1], Section 1020.The Nebraska Department of Transportation “Standard Specifications for Highway Construction,” (Section 603.03) requires contractors to mechanically insert tie bars into the face of pavements during construction. Tie bars …

Development Of An Ndt Tool For In-Situ Assessment Of Prestress Loss, Bibo Zhong, Jinying Zhu, George Morcous

Nebraska Department of Transportation: Research Reports

The research objective is to develop a non-destructive testing (NDT) method to evaluate the prestress loss in prestressed concrete bridge girders using ultrasonic waves. The work principle is based on acoustoelastic effect - ultrasonic wave velocity varies with stress level in prestressed concrete. A self-reference test setup was proposed to measure wave velocity in two orthogonal directions (prestress and unstressed directions) in the girder. This setup will be able to reduce effects of material variation and temperature change.

The concept was first validated on small concrete specimens (cylinders and beams) in laboratory. A signal analysis algorithm was developed to reliably …