Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Entire DC Network
Manufacturing And Analysis Of A Liga Heat Exchanger For The Surface Of A Tube: A Cooling Simulation Of The Leading Edge Region Of A Turbine Blade, Christophe Marques
Manufacturing And Analysis Of A Liga Heat Exchanger For The Surface Of A Tube: A Cooling Simulation Of The Leading Edge Region Of A Turbine Blade, Christophe Marques
LSU Doctoral Dissertations
Fabricating nickel micro heat exchangers directly on planar or non-planar metal surfaces has been demonstrated using the LIGA micromachining process. These heat exchangers can effectively control the temperature of surfaces in high heat flux applications. Of particular interest is the temperature control of gas turbine engine components. The locations in the gas turbine engine where improved, efficient cooling is required includes gas turbine blades, stator vanes, the turbine disk, and the combustor liner. In this dissertation, the primary application of interest is the use of such heat exchangers to cool airfoils such as turbine blades. In the first part of …
Micro Molding Of 3 D Ceramic Parts, Dinakar Palaparti
Micro Molding Of 3 D Ceramic Parts, Dinakar Palaparti
LSU Master's Theses
The objective of this research was to manufacture and evaluate three-dimensional (3D) ceramic parts with microstructures, characterize the ceramic injection molding process used for it along with fabrication and evaluation of various mold insert formats, electroplated patterns and X-ray masks used in the process. The patterns were electroplated in nickel on two formats of mold insert substrates. The first format was a modified 1” diameter stainless/tool steel plug suitable for test structures and for complete penetration by melt during injection. The molding was done by CoorsTekâ (Golden CO) as they possessed the required wherewithal and the mold base. The second …
Electrodeposition Of Nickel-Copper Alloys And Nickel-Copper-Alumina Nanocomposites Into Deep Recesses For Mems, Amrit Panda
Electrodeposition Of Nickel-Copper Alloys And Nickel-Copper-Alumina Nanocomposites Into Deep Recesses For Mems, Amrit Panda
LSU Doctoral Dissertations
Electrodeposition is an important component in the fabrication of micro electro mechanical systems (MEMS). Nickel is the most commonly used material to produce three dimensional microstructures and few material alternatives have been demonstrated. In this dissertation, electrodeposited Ni-Cu alloys and nanocomposites are investigated as possible replacements for nickel in microsystems. Ni-Cu alloys are attractive for their corrosion resistance, magnetic and thermophysical properties. Alumina nanoparticulates included into metal matrices improve hardness and tribology of deposits. The Ni-Cu alloys and Ni-Cu-g-Al2O3 nanocomposites were electrodeposited from a citrate electrolyte, both at low and high pH. Electrodeposition experiments were performed in recessed microelectrodes 500 …