Digital Commons Network^™

Behavior Of Channel-Shaped Reinforced Concrete Columns Under Combined Biaxial Bending And Compression, Dureseti Chidambarrao

Theses

The inelastic behavior of irregular shaped reinforced concrete columns has been a constant concern for a structural engineer, to design a safe and economic structure in modern buildings and bridge piers. The shape of the elements in a reinforced concrete structure may be used to optimize its structural strength, to make better use of the available space, to improve the aesthetic appearance of the structure, or to facilitate construction. Due to the locations of the columns, the shapes of the buildings and the nature of the applied loads, many columns are subject to combined biaxial bending and axial load.

Seven …

Analysis And Tests [Of] L-Shaped Reinforced Concrete Column Under Combined Biaxial Bending And Axial Compression, Alaedin Majlesi

Theses

A total of five tests on biaxially loaded column specimens were conducted to investigate the complete behavior of load-deformation characteristics from zero load until failure. The specimens were tested under horizontal position with 60 ton hydrolic jack. Pin end was used for both ends to obtain higher accuracy of plotting curves.

Two specimens were tested with dial gages to obtain load-deflection curves and the other three specimens were tested with demec and strain gages to obtain load strain and moment-curvature curves. The strain gages were measured by weston bridge and deme-gages were measured by mechanical dial gage.

The above moment-curvature …

Failure Surface For L-Shaped Reinforced Concrete Short Columns, Mon-Chen Liu

Theses

Combined bending and axial compression for L-shaped reinforced concrete short columns is a common problem. But the present ACI Building Code (ACI 318-77), handbooks and texbooks pay no attention to this problem. A numerical analysis and computer program developed by Hsu fora reinforced concrete member subject to biaxial bending and axial load has been used Using this computer program, the interaction diagrams and failure surface were developed for L-shaped members under combined bending and axial compression. A comparison between theoretical and experimental results was included to examine the validity of failure surface.