Digital Commons Network^™

The Reclamation Of Fibers From Blueprint Stock, Joseph A. Boyle

Paper Engineering Senior Theses

Object

A method of reclaiming the fibers from blueprint paper after it has been used in the photocopying precess and the subsequent bleaching of these fibers is sought.

A Photographic Study Of The Effects Of Beating On Fiber Structure, Gene D. Anderson

Paper Engineering Senior Theses

Because beating is the most fundamental, but highly important, process in the paper industry, some of the changes in fiber structure that occur during beating have been investigated. A literature survey is also presented concerning a number of related investigations of fiber structure.

The experimental results indicate that fibrillation begins very shortly after the beating process is started. As beating progresses, the primary cell wall is removed, and the specific area of the fiber increases greatly when the watery medium encounters the secondary lamella area of the fiber. Continued beating shows that the action is a mechanical one, in that …

An Investigation Of Nylon Fiber As A Papermaking Material, Robert J. Thiessen

Paper Engineering Senior Theses

Investigations were made to determine whether or not a practical method of bonding nylon-wood blend paper could be devised in which advantage is obtained from the strength qualities of the nylon fibers in the finished sheet. Two unsatisfactory methods were tried before a satisfactory method was found. By this method 25-to 50-per cent nylon content sheets were dipped in a five to ten-per cent solids water emulsion of a polyamide resin. The sheets were then dried, free of surface support, and then heat pressed to complete the bonding. Paper of high strength and durability was thus produced.

A Comparison Of Sheffield Instruments For Smoothness And Porosity With Others Now Used, John B. Yonker

Paper Engineering Senior Theses

This report shows that there is a correlation between Bekk and Sheffield smoothness and between Gurley and Sheffield porosity. The correlation is not as good in the upper Bekk smoothness range or in the upper Gurley range.

A Survey Of The Effect Of Mineral Salts On Direct Dyeings, Lawrence R. Bortolotti

Paper Engineering Senior Theses

A study of the effect of various minerals salts on dyeings made with direct dyes. Dyes were chosen for their frequency of usage in the paper industry; the salts were chosen for several reasons, the prime one being that they form a floc at approximately the same pH as that of the stock run over the paper machine, also for its cost and availability. Sheets were made with the various dyes and salts in severals percentages of each dried, out up into test sheets for fading and bleeding. The test sheets were examined visually for evidence of fading and bleeding …

Impartial Evaluations Of The Printing Quality Of Paper, Warren R. Engel

Paper Engineering Senior Theses

Several methods for the evaluation of paper have been investigated for their desirability as means of an impartial evaluation of the printing quality of paper. The halftone plate method showed the most desired results as an impartial evaluation of both coated and uncoated papers. The printing gage was not found to be a satisfactory method of evaluation. The drawdown method is especially significant in evaluating properties which influence the printing quality but lacks a suitable numerical evaluation.