Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Entire DC Network
The Effect Of Incorporating End-User Customization Into Additive Manufacturing Designs, Jonathan D. Ashley
The Effect Of Incorporating End-User Customization Into Additive Manufacturing Designs, Jonathan D. Ashley
Graduate Theses and Dissertations
In the realm of additive manufacturing there is an increasing trend among makers to create designs that allow for end-users to alter them prior to printing an artifact. Online design repositories have tools that facilitate the creation of such artifacts. There are currently no rules for how to create a good customizable design or a way to measure the degree of customization within a design. This work defines three types of customizations found in additive manufacturing and presents three metrics to measure the degree of customization within designs based on the three types of customization. The goal of this work …
Utilizing 3d Printed Analogue Soils To Investigate Specimen Size Effects In Triaxial Testing, Claire Louise Stewart
Utilizing 3d Printed Analogue Soils To Investigate Specimen Size Effects In Triaxial Testing, Claire Louise Stewart
Graduate Theses and Dissertations
Triaxial testing is one of the fundamental laboratory tests used in geotechnical engineering to determine strength parameters, such as shear strength and friction angle. Investigating the minimum representative elementary volume (REV) can verify the independence of size effects on strength parameters and ensure that the scaled laboratory tests results are consistent, repeatable, and representative of field conditions. Although, REV has been studied for many applications, there is disagreement within geotechnical engineering of a minimum particle diameter to specimen diameter to minimize the size effects related to the REV in consolidated drained (CD) triaxial tests. This research study compared the strength …
Microheater Array Powder Sintering (Maps) For Printing Flexible Electronics, Nicholas Holt
Microheater Array Powder Sintering (Maps) For Printing Flexible Electronics, Nicholas Holt
Graduate Theses and Dissertations
Microheater array powder sintering (MAPS) is a novel additive manufacturing process that uses an array of microheaters to selectively sinter powder particles. MAPS shows great promise as a new method of printing flexible electronics by enabling digital curing of conductive inks on a variety of substrates. MAPS operation relies on establishing a precision air gap of a few microns between an array of microheaters, which can reach temperatures of 600°C, and a layer of conductive ink which can be deposited onto a flexible substrate. This system presents challenges, being: the fabrication of a microheater that can reach suitable temperatures in …