Digital Commons Network^™

Aluminum And Phosphorus Separation: Application To Preparation Of Target From Brain Tissue For 26Al Determination By Accelerator Mass Spectrometry, Russell D. Brauer, J. David Robertson, Pankaj Sharma, Robert A. Yokel

Pharmaceutical Sciences Faculty Publications

Acid digested brain containing 4 mg added ²⁷Al was ashed at 1000°C to prepare an Al₂O₃ target for accelerator mass spectrometry (AMS) analysis of ²⁶Al. A glass-like material usually resulted which was thought to be aluminum (Al) oxyphosphate. The separation of Al and phosphate was investigated. Al, but not phosphate, was bound by a cation exchange resin (AG 50-X8). Hydrofluoric acid eluted the Al from the resin. Removal of phosphate from acid digested brain by this method produced an amorphous material after ashing that was easier to recover from the porcelain crucible and had a …

Cracking In Cycloaliphatic Epoxy/Aluminum Composite Electrical Bushings, Keith Alan Parker

Doctoral Dissertations

The problem of cracking in electrical apparatus bushings as a result of thermal stresses was investigated. The bushings were composed of cycloaliphatic epoxy insulators with embedded aluminum conductors. The problem is due to the difference in coefficients of thermal expansion of the two materials. A solution to the problem had been to coat the conductors before they were formed together with the epoxy insulators. The coating was assumed to prevent cracking by allowing movement between the two materials as their dimensions changed during thermal expansion and contraction. The contribution of the coating was to be established.

The hypothesis was that …

A Comparative Wear Study On Heat-Treated Aluminium-Lithium Alloy And Pure Aluminium

A.S. Md Abdul Haseeb

Wear behaviour of solution-treated and aged aluminium-lithium alloy (2.5% Li, 2% Cu, 1% Mg and 0.15% Zr) was compared with that of pure aluminium. Wear tests were carried out in ambient air in a pin-on-disc type apparatus under dry sliding conditions using hardened steel disc as the counterbody. A normal load of 10 N and a linear speed of 0.98 m s-1 were used during the tests. Microscopic investigation, microhardness measurement on the subsurface of wear scars on pins, X-ray diffraction study and morphological examination of wear debris were done to elucidate wear mechanism. It has been found that the …

A Comparison Of Aluminum To Ceramic Lap Tools In Optical Lens Surfacing, Derek M. Walls

OTS Master's Level Projects & Papers

The purpose of this study was to determine if ceramic lap tools produce as high a quality of optical lenses as aluminum lap tools during the surfacing process in eye ware manufacturing, if ceramic lap tools are easier or harder to work with than aluminum lap tools, if ceramic lap tools last as long as aluminum lap tools, and if ceramic tolls are as cost effective as aluminum lap tools.