Open Access. Powered by Scholars. Published by Universities.®

Digital Commons Network

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Entire DC Network

Agricultural Situation And Outlook Fall 2006, James Mansfield, Timothy A. Woods Oct 2006

Agricultural Situation And Outlook Fall 2006, James Mansfield, Timothy A. Woods

Agricultural Situation and Outlook

No abstract provided.


Development And Testing Of A Low-Cost Condensation Detection System, Michael D. Montross, George A. Duncan, Richard S. Gates Jul 2006

Development And Testing Of A Low-Cost Condensation Detection System, Michael D. Montross, George A. Duncan, Richard S. Gates

Biosystems and Agricultural Engineering Faculty Publications

A condensation sensing and control system was designed to detect condensation using a commercially available leaf wetness sensor (LWS). The leaf wetness sensor was a variable resistance grid-type that responded to moisture on the surface. A circuit was developed to compare the LWS voltage output to a user specified reference voltage, and operate a relay for possible switching of a humidity control device (for example a fan and/or heater). The condensation detection system operation was validated in an environmental chamber in the laboratory using a heat exchanger and water bath. Condensate was immediately detected when the plate was cooled below …


Vertical Loads Due To Wheat On Obstructions Located On The Floor Of A Model Bin, Marek Molenda, Michael D. Montross, Sidney A. Thompson, Jozef Horabik Jan 2006

Vertical Loads Due To Wheat On Obstructions Located On The Floor Of A Model Bin, Marek Molenda, Michael D. Montross, Sidney A. Thompson, Jozef Horabik

Biosystems and Agricultural Engineering Faculty Publications

Tests were conducted in a model grain bin to evaluate the vertical loads acting on differently shaped obstructions embedded in wheat during filling, detention, and discharge. The bin had corrugated galvanized steel walls with a 1.83 m diameter and a flat bottom. All tests were conducted in a bin that was centrically loaded and unloaded. Three differently shaped obstructions (disc, cone, and cylinder) were tested; each had a circular base equivalent to 6% of the bin floor area. The obstructions were supported in the bin using a three-legged support structure. Each leg of the support structure rested on a load …


The Kentucky Agricultural Economic Outlook For 2006, Linda Inman, A. Lee Meyer, Gina Wilkie Jan 2006

The Kentucky Agricultural Economic Outlook For 2006, Linda Inman, A. Lee Meyer, Gina Wilkie

Kentucky Agricultural Economic Outlook

No abstract provided.