Open Access. Powered by Scholars. Published by Universities.®

Digital Commons Network

Open Access. Powered by Scholars. Published by Universities.®

PDF

Mechanical Engineering

Selected Works

Aluminum

Selected Works

2015

Articles 1 - 2 of 2

Full-Text Articles in Entire DC Network

The Effects Of Patch Properties On The Debonding Behavior Of Patched Beam-Plates, Anette M. Karlsson Feb 2015

The Effects Of Patch Properties On The Debonding Behavior Of Patched Beam-Plates, Anette M. Karlsson

Anette M Karlsson

The debonding characteristics of patched structures are investigated in this study by means of an analytical model. In particular, the effects the lay-up sequence and edge tapering of a carbon-reinforced epoxy patch, as well as the beveling of an aluminum patch, have on the initiation, stability, and extent of the debonding are considered. The results presented show that both the degree of edge-tapering and the patch properties must be carefully selected in order to optimize the patched structure. It is also shown that when designing a patched system, it is important to model the correct boundary and load conditions to ...


Fuzzy Logic Based Model For Predicting Surface Roughness Of Machined Al-Si-Cu-Fe Die Casting Alloy Using Different Additives-Turning Jan 2015

Fuzzy Logic Based Model For Predicting Surface Roughness Of Machined Al-Si-Cu-Fe Die Casting Alloy Using Different Additives-Turning

Faculty of Engineering University of Malaya

This paper presents a fuzzy logic artificial intelligence technique for predicting the machining performance of Al-Si-Cu-Fe die casting alloy treated with different additives including strontium, bismuth and antimony to improve surface roughness. The Pareto-ANOVA optimization method was used to obtain the optimum parameter conditions for the machining process. Experiments were carried out using oblique dry CNC turning. The machining parameters of cutting speed, feed rate and depth of cut were optimized according to surface roughness values. The results indicated that a cutting speed of 250 m/min, a feed rate of 0.05 mm/rev, and a depth of cut ...