Digital Commons Network^™

Use Of Sodium Bismuthate Chromatography For Separation Of Americium From Curium And Other Elements In Spent Nuclear Fuel, Jason Michael Richards

UNLV Theses, Dissertations, Professional Papers, and Capstones

A novel method for partitioning americium from curium has been developed using sodium bismuthate as both an oxidant and a separation medium. The presence of americium and curium in nuclear waste increases the heat load in geological repositories and leads to larger waste volumes. These elements are also the source of most of the long-term radiotoxicity of the waste. However, the heat load and long-term radiotoxicity contribution from americium is much greater than that from curium. The contribution of curium to the heat load and radiotoxicity of the waste is significant on the same time scale as longer-lived fission products …

Speciation Behavior Of Americium Higher Oxidation States For The Separation Of Americium From Curium, Catherine Lynn Riddle

UNLV Theses, Dissertations, Professional Papers, and Capstones

Several countries are currently expanding the use of nuclear energy as a method for the safe generation of carbon free energy and a number are evaluating starting up a nuclear power program. Closed fuel cycle technologies may be key to waste reduction and a sustainable nuclear energy future and to support the development of more efficient fuel cycles, the investigation of the chemical properties of key actinides is at the forefront of separations research. In this work the characterization of higher oxidation states of americium (Am) has been performed using spectroscopic methods. Americium in the formal oxidation state of Am(V) …

Intragroup Separation Of Trivalent Lanthanides And Actinides For Neutron Capture Experiments In Stockpile Stewardship Sciences, Narek Gharibyan

UNLV Theses, Dissertations, Professional Papers, and Capstones

Knowledge of low-energy cross sections for stable and unstable nuclei in neutron-, γ- and ion induced reactions is important in both the simulation and radiochemistry diagnosis of nuclear device performance. This dissertation explores extraction chromatography and ion chromatography methods for the intragroup separation of trivalent actinides and lanthanides in support of cross section measurements for isotopes of interest. For trivalent actinides, americium (Am(III)) and curium (Cm(III)), separation is necessary to assist in experiments related to the measurement of neutron capture cross section for ²⁴¹ Am and the production of ^{242 m} Am/^242g Am isomeric ratio. Extraction chromatography resins …

Electrochemical Separation Of Curium And Americium, David W. Hatchett, Kenneth Czerwinski

Separations Campaign (TRP)

The objective was to use electrochemical techniques to develop a thermodynamic understanding of actinide and lanthanide species in RTIL solutions, and use this data to effectively separate species with very similar chemical properties.

In consultation with a DOE collaborator, electrochemical methods and materials were evaluated and used to exploit the thermodynamic differences between similar chemical species enhancing the ability to selectively target and sequester individual species from mixtures. This project, in its third year, successfully completed phases 1, 2. Phase 3 was partially completed. The project expanded to include phase 4.

The following were specific goals for 2007-2008:

• To …

Electrochemical Separation Of Curium And Americium, David W. Hatchett, Kenneth Czerwinski

Separations Campaign (TRP)

The objectives of this project are to use electrochemical techniques to develop a thermodynamic understanding of actinide and lanthanide species in RTIL solution, and to use this data to effectively separate species with very similar chemical properties. In consultation with a national laboratory collaborator, electrochemical methods and materials will be evaluated and used to exploit the thermodynamic differences between similar chemical species, enhancing the ability to selectively target and sequester individual species from mixtures. This project is in its third year and has successfully completed phases 1 and 2. Phase 3 has been partially completed. The tasks have been expanded …

The Electrochemical Separation Of Curium And Americium: Quaterly Report January - March, 2006, David W. Hatchett, Kenneth Czerwinski

Separations Campaign (TRP)

This research report outlines the current status and progress associated with the electrochemical separation of Curium and Americium. For two and a half years, research has been actively performed on this project, and is currently on schedule for the proposed timelines.

Progress:

• The electrochemical characterization of Ce and Eu complexed with EDTA, NTA, and Citrate has been completed.

• Synthesis of the polymer substrate and the chelating ligand is underway. Approximately 50 grams of disulfide has been produced to produce the chelating thiol group required for the last set of studies.

• Gold substrates have been prepared to perform …

Electrochemical Separation Of Curium And Americium, David W. Hatchett, Kenneth Czerwinski

Separations Campaign (TRP)

The objective of this project is to use electrochemical techniques to develop a thermodynamic understanding of actinide and lanthanide species in aqueous solution and use this data to effectively separate species with very similar chemical properties. In consultation with a national laboratory collaborators, electrochemical methods and materials will be evaluated and used to exploit the thermodynamic differences between similar chemical species enhancing the ability to selectively target and sequester individual species from mixtures. This project is in its third year and has successfully completed Phases 1 and 2.

The following were specific goals for this year:

• To develop a fundamental …

The Electrochemical Separation Of Curium And Americium: Quaterly Report April - June, 2005, David W. Hatchett, Kenneth Czerwinski

Separations Campaign (TRP)

This research report outlines the current status and progress associated with the electrochemical separation of Curium and Americium.

Results

• We have completed the electrochemical investigation in of the Ce³⁺/Ce⁴⁺ redox couple and have determined the optimum experimental conditions.

• Computer modeling of the cerium using the JChess speciation-modeling program has been completed for the Ce redox couple. Traditional complexing ligands such as EDTA, oxalate, NTA, phosphate, acetate, and sulfate have been purchased and will be used to initiate the complexation and electrochemical characterization.

• Electrochemical investigations have continued on the Eu²⁺/Eu³⁺ redox …

Electrochemical Separation Of Curium And Americium, David W. Hatchett, Kenneth Czerwinski

Separations Campaign (TRP)

The objective of this project is to use electrochemical techniques to develop a thermodynamic understanding of actinide and lanthanide species in aqueous solution and use this data to effectively separate species with very similar chemical properties. In consultation with our DOE collaborator, electrochemical methods and materials will be evaluated and used to exploit the thermodynamic differences between similar chemical species enhancing our ability to selectively target and sequester individual species from mixtures.

The following were specific goals for this year:

• To develop a fundamental understanding of the thermodynamic properties of actinide and lanthanide species such as Cm, Am, Ce, Nd, …

The Electrochemical Separation Of Curium And Americium: Quaterly Report August-December 2004, David W. Hatchett, Kenneth Czerwinski

Separations Campaign (TRP)

This research report outlines the current status and progress associated with the electrochemical separation of Curium and Americium. The following pages outline the progress on our project to date. We have been actively performing research on this project for three months and are currently on schedule in terms of the proposed timelines.

The initial focus of the project involved setting up the laboratories for the studies outlined in the grant proposal. The instrumentation needed included an electrochemical work station that will perform the bulk of the electrochemical studies. This instrument will complement the electrochemical instrumentation in Dr. Hatchett’s laboratory and …

Electrochemical Separation Of Curium And Americium, David W. Hatchett, Kenneth Czerwinski

Separations Campaign (TRP)

The objective of this project is to develop a method for the separation of Am from Cm based on electrochemical techniques. Electrochemical systems that allow the thermodynamics of actinide and lanthanide complexes to be systematically evaluated and tuned will be examined. The influence of complex formation on the ability to selectively isolate a given species electrochemically will be evaluated. Metal-ligand complex formation provides a useful derivation technique to increase solubility in solution environments that favor precipitation. In addition, the thermodynamic properties of a complex relative to the isolated species may be shifted to more suitably measurable electrochemical separation regimes. Electrochemical …

Design And Simulation Of An Induction Skull Melting System, Taide Tan

UNLV Theses, Dissertations, Professional Papers, and Capstones

Incorporating volatile actinides, mainly americium into a metallic fuel pin (MFP) has been a serious problem due to americium’s high vapor pressure. An Induction Skull Melting (ISM) system was identified by Argonne National Laboratory (ANL) as a potential furnace design to cast MFPs. Through the development of the ISM system, the nuclear waste feedstock can be melted and injected into the mold for fabricating MFPs in the advanced nuclear fuel cycles. The main phenomena in this system include: induction melting process, casting process and mass transfer process of americium. Issues related to ISM system design for casting MFPs are discussed …

The Electrochemical Separation Of Curium And Americium: Quaterly Report January - March 2004, David W. Hatchett, Kenneth Czerwinski

Separations Campaign (TRP)

This research report outlines the current status and progress associated with the electrochemical separation of Curium and Americium.

Data collection and analysis of the Ce³⁺/Ce⁴⁺ redox couple in various supporting electrolytes has continued. All electrolyte systems were investigated at Pt, Au, and Glassy Carbon working electrodes. Analysis of these data was accomplished by performing appropriate background subtractions to reveal net peaks due to Ce redox behavior. Successful identification of the Ce redox couple was achieved with all electrolyte/electrode systems, although a decline in peak resolution was observed with increasing acid concentration. Optimal conditions in this experiment were …

Design And Analysis For Melt Casting Metallic Fuel Pins Incorporating Volatile Actinides, Xiaolong Wu

UNLV Theses, Dissertations, Professional Papers, and Capstones

Fundamental issues related to the selection of a metallic fuel casting furnace design are presented and discussed including heating mechanisms, casting issues, crucible design, and issues related to the mass transport of americium. The process of evaluating all of these different criteria is undertaken to select a concept that would have the greatest chance of success for casting americium in a metallic fuel rod. Based on this evaluation process, a concept for the casting of metallic fuel pins containing high vapor pressure materials is selected and discussed. The important physics of this concept include mass transport of americium from the …