Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Entire DC Network
A Kinematic Analysis Of Joint Angle And Center Of Mass Kinematics In Automotive Manufacturing Tasks, Jarrod Smith
A Kinematic Analysis Of Joint Angle And Center Of Mass Kinematics In Automotive Manufacturing Tasks, Jarrod Smith
Electronic Theses and Dissertations
This research aimed to determine if participants of varying anthropometrics (i.e., height) would perform automotive manufacturing tasks significantly differently based on joint angle and center of mass (COM) data. Twenty-four participants between the ages of 18 and 65 (¯x = 24.1 years, SD = 7.3) completed 14 manufacturing tasks, and their motions were recorded using two inertial motion capture (IMC) systems. Participants were chosen based on their measured height, including the 5th percentile female (Group 1-5F), 50th percentile female (Group 2-50F), or 95th percentile male (Group 3-95M) (Fryar, Gu, Ogden & Flegal, 2016). The tasks used for this study were …
Barbell Trajectory And Kinematics During Two International Weightlifting Championships, Aaron J. Cunanan
Barbell Trajectory And Kinematics During Two International Weightlifting Championships, Aaron J. Cunanan
Electronic Theses and Dissertations
Several methods have been used in the scientific literature to study the weightlifting pull. Broadly, these methods are used to measure kinematic or kinetic variables exhibited by the lifter, the barbell, or the lifter-barbell system. However, there is an apparent disconnect between weightlifting research and coaching practice that may reduce the perceived benefits of technique analysis among coaches and present some challenges for coaches who seek to incorporate technique analysis into their coaching practice. Differences and trends in the technique of competitive weightlifting performances are apparent from the available literature. However, there are also gaps in the literature due to …