Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Entire DC Network
Ni-Doped Sr2Fe1.5Mo0.5O6-Δ As Anode Materials For Solid Oxide Fuel Cells, Guoliang Xiao, Siwei Wang, Ye Lin, Zhibin Yang, Minfang Han, Fanglin Chen
Ni-Doped Sr2Fe1.5Mo0.5O6-Δ As Anode Materials For Solid Oxide Fuel Cells, Guoliang Xiao, Siwei Wang, Ye Lin, Zhibin Yang, Minfang Han, Fanglin Chen
Faculty Publications
10% Ni-doped Sr2Fe1.5Mo0.5O6-δ with A-site deficiency is prepared to induce in situ precipitation of B-site metals under anode conditions in solid oxide fuel cells. XRD, SEM and TEM results show that a significant amount of nano-sized Ni-Fe alloy metal phase has precipitated out from Sr1.9Fe1.4Ni0.1Mo0.5O6-δ upon reduction at 800◦C in H2. The conductivity of the reduced composite reaches 29 S cm−1 at 800◦C in H2. Furthermore, fuel cell performance of the composite anode Sr1.9 …
Increasing Power Density Of Lsgm-Based Solid Oxide Fuel Cells Using New Anode Materials, Kevin Huang, Jen-Hau Wan, John B. Goodenough
Increasing Power Density Of Lsgm-Based Solid Oxide Fuel Cells Using New Anode Materials, Kevin Huang, Jen-Hau Wan, John B. Goodenough
Faculty Publications
Chemical reactions between the superior perovskite oxide-ion conductor Sr- and Mg-doped LaGaO3 (LSGM), CeO2, and NiO have been studied by powder X-ray diffraction. The results showed that an extensive reactivity occurs as a result of La migration driven by a gradient of La chemical activity. La migration across the LSGM/electrode interfaces in a fuel cell leads to the formation of resistive phases at the interface, either LaSrGa3O7 or LaSrGaO4. Use of 40 mol % La2O3 -doped CeO2 as an interlayer between anode and electrolyte as well as in …
Sr‐ And Ni‐Doped Lacoo3 And Lafeo3 Perovskites: New Cathode Materials For Solid‐Oxide Fuel Cells, Kevin Huang, Hee Y. Lee, John B. Goodenough
Sr‐ And Ni‐Doped Lacoo3 And Lafeo3 Perovskites: New Cathode Materials For Solid‐Oxide Fuel Cells, Kevin Huang, Hee Y. Lee, John B. Goodenough
Faculty Publications
An improved cathode material for a solid‐oxide fuel cell would be a mixed electronic and oxide‐ion conductor with a good catalytic activity for oxygen reduction at an operating temperature T op ≥ 700°C and a thermal expansion matched to that of the electrolyte and interconnect. We report on the properties of Sr‐ and Ni‐doped LaCoO3 and LaFeO3 perovskites that meet these criteria. Single‐phase regions were determined by X‐ray diffraction, and thermogravimetric analysis measurements were used to obtain the temperatures above which oxygen loss, and hence oxide‐ion conductivity, occurs. The conductivity and Seebeck measurements indicate the coexistence of both …
Characterization Of Sr‐Doped Lamno3 And Lacoo3 As Cathode Materials For A Doped Lagao3 Ceramic Fuel Cell, Kevin Huang, Man Feng, John B. Goodenough, Michael Schmerling
Characterization Of Sr‐Doped Lamno3 And Lacoo3 As Cathode Materials For A Doped Lagao3 Ceramic Fuel Cell, Kevin Huang, Man Feng, John B. Goodenough, Michael Schmerling
Faculty Publications
Energy dispersive spectrometry line scan and ac impedance spectroscopy were used in this study to investigate the chemical reactions between two cathode materials, La0.84Sr0.16MnO3 (LSM), La0.5Sr0.5CoO3-δ (LSC), and the electrolyte La0.9Sr0.1Ga0.8Mg0.2O2.85 (LSGM). Significant interdiffusions of Co into LSGM and Ga into LSC were found at an LSC/LSGM interface even at relatively low fabrication temperatures. In contrast, only small interdiffusions of Mn into LSGM and Ga into LSM were detected at the LSM/LSGM interface even though it was fired at 1470°C. The …