Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Entire DC Network
Characterizing The Frictional Interface In Friction Stir Welding, Daryl A. Stratton
Characterizing The Frictional Interface In Friction Stir Welding, Daryl A. Stratton
Theses and Dissertations
Quantitative understanding of frictional phenomena between the tool and the workpiece is essential for accurate modeling of the Friction Stir Welding (FSW) process. Two methods of measuring the tool-workpiece interface are proposed that allow frictional measurements to be made under extreme conditions. The first method uses a cylindrically curved surface in contact with a flat plate. The ranges of temperature, velocity, and normal force used in this method are 100–600°C, 0.38–2.0 m/s (75–400) surface feet per minute (SFM)), and 450–2700 N (100–600 lbf), respectively. Data are gathered at different parameter level combinations to provide enough data to create an empirical …
Spot Friction Welding Of Ultra High-Strength Automotive Sheet Steel, Jack H. Sederstrom
Spot Friction Welding Of Ultra High-Strength Automotive Sheet Steel, Jack H. Sederstrom
Theses and Dissertations
Spot friction welding (SFW) was performed on ultra high strength steel (UHSS) steel sheet commonly used in automobile manufacturing. Alloys studied included DP780, DP780EG, DP980, and DF140T sheet steel of varying thickness from 1.2 mm to 1.4 mm. Welding was accomplished using a PCBN standard tool. Weld strengths were then compared to a proposed AWS standard. Initial hardness readings were taken in cross sectioned samples. Grain structure in a SFW is presented. Resistance spot welds were created in three steels. This study focuses on the strength of SFW joints as compared to traditional resistance spot welding (RSW) in welding like …