Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Entire DC Network
Friction Stir Welding Of High-Strength Automotive Steel, Eric Michael Olsen
Friction Stir Welding Of High-Strength Automotive Steel, Eric Michael Olsen
Theses and Dissertations
The following thesis is a study on the ability to create acceptable welds in thin-plate, ultra-high-strength steels (UHSS) by way of friction stir welding (FSW). Steels are welded together to create tailor-welded blanks (TWB) for use in the automotive industry. Dual Phase (DP) 590, 780, and 980 steel as well as Transformation-Induced Plasticity (TRIP) 590 steel with thicknesses ranging from 1.2 mm to 1.8 mm were welded using friction stir welding under a variety of processing conditions, including experiments with dissimilar thicknesses. Samples were tested under tensile loads for initial determination if an acceptable weld had been created. Acceptable welds …
Characterizing The Frictional Interface In Friction Stir Welding, Daryl A. Stratton
Characterizing The Frictional Interface In Friction Stir Welding, Daryl A. Stratton
Theses and Dissertations
Quantitative understanding of frictional phenomena between the tool and the workpiece is essential for accurate modeling of the Friction Stir Welding (FSW) process. Two methods of measuring the tool-workpiece interface are proposed that allow frictional measurements to be made under extreme conditions. The first method uses a cylindrically curved surface in contact with a flat plate. The ranges of temperature, velocity, and normal force used in this method are 100–600°C, 0.38–2.0 m/s (75–400) surface feet per minute (SFM)), and 450–2700 N (100–600 lbf), respectively. Data are gathered at different parameter level combinations to provide enough data to create an empirical …