Digital Commons Network^™

Uncertainty Quantification Integrated To Cfd Modeling Of Synthetic Jet Actuators, Srikanth Adya, Daoru Frank Han, Serhat Hosder

Mechanical and Aerospace Engineering Faculty Research & Creative Works

The Point-Collocation Non-intrusive Polynomial Chaos (NIPC) method has been applied to a stochastic synthetic jet actuator problem used as one of the test cases in the CFDVAL2004 workshop to demonstrate the integration of computationally efficient uncertainty quantification to the high-fidelity CFD modeling of synthetic jet actuators. The test case included the simulation of an actuator generating a synthetic jet issued into quiescent air. The Point-Collocation NIPC method is used to quantify the uncertainty in the long-time averaged u and v-velocities at several locations in the flow field due to the uniformly distributed uncertainty introduced in the amplitude and frequency of …

Modeling Of Thermal Non-Equilibrium In Superheated Injector Flows, Shivasubramanian Gopalakrishnan

Open Access Dissertations

Among the many factors that effect the atomization of a fuel spray in a com- bustion chamber, the flow characteristics of the fuel inside the injector nozzle play significant roles. The enthalpy of the entering fuel can be elevated such that it is higher than the local or downstream saturation enthalpy, which will result in the flash-boiling of the liquid. The phase change process dramatically effects the flow rate and has the potential to cause subsonic two-phase choking. The timescale over which this occurs is comparable to the flow-through time of the nozzle and hence any attempt to model this …

Simulations Of Flow Over Wind Turbines, Dnyanesh A. Digraskar

Masters Theses 1911 - February 2014

One of the most abundant sources of renewable energy is wind. Today, a considerable amount of resources are being utilized for research on harnessing the wind energy efficiently. Out of all the factors responsible for efficient energy production, the aerodynamics of flow around the wind turbine blades play an important role. This work aims to undertake aerodynamic analysis of a Horizontal Axis Wind Turbine. A steady state, incompressible flow solver for multiple reference frames, MRFSimple- Foam is modified and used for performing simulations of flow over National Renewable Energy Laboratory Phase VI wind turbine rotor. The code is first tested …

Laminar-Turbulent Transition For Attached And Separated Flow, Qian Zhang

University of Kentucky Doctoral Dissertations

A major challenge in the design of turbomachinery components for aircraft gas turbine engines is high cycle fatigue failures due to flutter. Of particular concern is the subsonic/transonic stall flutter boundary which occurs at part speed near the stall line. At these operating conditions the incidence angle is large and the relative Mach number is high subsonic or transonic. Viscous effects dominate for high incidence angles.

In order to predict the flutter phenomena, accurate calculation of the steady and unsteady aerodynamic loading on the turbomachinery airfoils is necessary. The development of unsteady aerodynamic models to predict the unsteady forces and …