Digital Commons Network^™

Quantifying The Dynamics Of An Idealized Oil-Plume In Stratified Environment Using Direct Numerical Simulations, Jasmin Ahmed

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Deep-water oil spills such as the incident in the northern Gulf of Mexico 2010, produce turbulent oil plumes. Multiphase turbulent plumes under stratification are simulated to understand the dynamics of oil plume in oceanic environment. The evolution of the plume is strongly affected by the level of turbulent mixing during the rise of oil through the stratified water. The relative velocity due to the difference in density between oil and water causes slip of oil in water. The plume has been modeled as a two fluid mixture-model, which allows the use of one continuity and momentum equation for the oil-water …

Best Practices For Volume Flow Rate Measurements Using Piv At The Exit Of A Turbulent Planar Jet, Rick Cressall

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Particle image velocimetry (PIV) is used to make volume-flow-rate measurements at the exit of a turbulent, planar nozzle. The objective of this report is to assess a range of data acquisition and processing parameters. Data is acquired for volume flow rates of Reynolds numbers between 10,000 and 100,000 for both two-component (2C) and stereo PIV. The parameters are systematically changed one at a time and evaluated using differences in uncertainty, calculation time, and volume- flow-rate deviation. Data acquisition parameters follow the trends of previous work. A multitude of processing parameters were varied for several PIV processing methods. Recommendations for each …

Computational Fluid Dynamic Modeling Of Natural Convection In Vertically Heated Rods, Mahesh Surendran

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Natural convection is a phenomenon that occurs in a wide range of applications such as cooling towers, air conditioners, and power plants. Natural convection may be used in decay heat removal systems such as spent fuel casks, where the higher reliability inherent of natural convection is more desirable than forced convection. Passive systems, such as natural convection, may provide better safety, and hence have received much attention recently. Cooling of spent fuel rods is conventionally done using water as the coolant. However, it involves contaminating the water with radiation from the fuel rods. Contamination becomes dangerous and difficult for humans …

Verification And Validation Of The Spalart-Allmaras Turbulence Model For Strand Grids, Oisin Tong

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The strand-Cartesian grid approach is a unique method of generating and computing fluid dynamic simulations. The strand-Cartesian approach provides highly desirable qualities of fully-automatic grid generation and high-order accuracy. This thesis focuses on the implementation of the Spalart-Allmaras turbulence model to the strand-Cartesian grid framework. Verification and validation is required to ensure correct implementation of the turbulence model.

Mathematical code verification is used to ensure correct implementation of new algorithms within the code framework. The Spalart-Allmaras model is verified with the Method of Manufactured Solutions (MMS). MMS shows second-order convergence, which implies that the new algorithms are correctly implemented.

Validation …

Evaluation Of Turbulence Variable Distributions For Incompressible Fully Rough Pipe Flows, Emilie B. Fowler

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The specific turbulent kinetic energy, root-mean-square fluctuating vorticity, and mean-vortexwavelength distributions are presented for fully rough pipe flow. The distributions of these turbulence variables are obtained from a proposed turbulence model. Many of the turbulence models commonly used for computational fluid dynamics are based on an analogy between molecular and turbulent transport. However, traditional k-ε and k-ω models fail to exhibit proper dependence on the molecular viscosity. Based on a rigorous application of the Boussinesq’s hypothesis, Phillips proposed a vorticity-based transport equation for the turbulent kinetic energy. The foundation for this vorticity-based transport equation is presented. In future development of …

Turbulence Modeling Of Strongly Heated Internal Pipe Flow Using Large Eddy Simulation, Michal Hradisky

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

The main objective of this study was to evaluate the performance of three Large Eddy Simulation (LES) subgrid scale (SGS) models on a strongly heated, low Mach number upward gas flow in a vertical pipe with forced convection. The models chosen for this study were the Smagorinsky-Lilly Dynamic model (SLD), the Kinetic Energy Transport model (KET), and the Wall-Adaptive Local-Eddy viscosity model (WALE). The used heating rate was sufficiently large to cause properties to vary significantly in both the radial and streamwise directions. All simulations were carried out using the commercial software FLUENT.

The effect of inlet turbulence generation techniques …

Toward The Validation Of Depth-Averaged, Steady-State Simulations Of Fluvial Flows Using Three-Dimensional, Steady-State, Rans Turbulence Models, Pedro Abdiel Mateo Villanueva

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Calculations of fluvial flows are strongly influenced by geometry complexity and large overall uncertainty on every single measurable property, such as velocity and shear. Moreover, a considerable portion of the data obtained from computational simulations arose from two-dimensional, steady-state models. The present work states a different approach to perform computer-based simulations and analyze fluvial flows. For the first part, the suitability of OpenFOAM to be used as the main CFD solver to analyze fluvial flows is studied. Initially, two well documented channel configurations are computationally studied using OpenFOAM. Finally, these results are compared to the output obtained from one of …