Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Entire DC Network
An Experimental Investigation Of Heat Transfer For Arrays Of Impingement Jets Onto The Featured Surfaces With Cylindrical And Elliptical Raised Surfaces, Marc A. Medina
Honors Undergraduate Theses
This study focuses on multi-jet impingement for gas turbine geometries in which the objective is to understand the influence of the roughness elements on a target surface to the heat transfer. Current work has proven that implementing roughness elements for multi-jet impingement target surfaces has increased heat transfer ranging anywhere from 10-30%. This study has chosen to investigate three different roughness elements, elliptical in cross-section, to compare to smooth surface geometries for multi-jet impingement. An experimental was taken for this study to extend the current knowledge of multi-jet impingement geometries and to further understand the heat transfer performance. A temperature …
Study Of Discharge Coefficient And Trends In Film Cooling Effectiveness Of Conical Holes With Increasing Diffusion Angles, Humberto Zuniga,
Study Of Discharge Coefficient And Trends In Film Cooling Effectiveness Of Conical Holes With Increasing Diffusion Angles, Humberto Zuniga,
Electronic Theses and Dissertations
Previous studies indicate that increasing the diffusion angle in conical film-cooling holes leads to an improvement in their film cooling effectiveness. Discharge coefficient and film cooling effectiveness measurements are conducted to characterize this behavior. Part of the focus of this investigation is to find out how this trend develops and attempt to ascertain the optimum cone angle, if possible. Six test plates, each with one row of eight conical-shaped cooling holes of equal diffusion angles of 0, 1, 2, 3, 6, or 8 [degrees], with respect to the hole axis are used in this study. The ratios of the hole …
A Dynamic Model Of The Human/Cooling System/Clothing/Environment System, Zhengxiang Pu
A Dynamic Model Of The Human/Cooling System/Clothing/Environment System, Zhengxiang Pu
Electronic Theses and Dissertations
The human body compensates well for moderate climatic heat stress, but artificial environments often block or overwhelm physiological defense mechanism. Personal protective equipment (PPE) is one of sources of heat stress. It protects individual from chemical, physical, or biological hazards, but the high thermal insulation and low vapor permeability of PPE may also lead to substantial heat stress. Personal cooling is widely used to alleviate heat stress, especially for those situations where ambient environmental cooling is not economically viable or feasible. It is important to predict the physiological responses of a person wearing PPE with personal cooling to make sure …