Open Access. Powered by Scholars. Published by Universities.®
- Keyword
-
- Accuracy (1)
- Aspergillus niger (1)
- Asymmetry (1)
- Bulk density (1)
- Compressibility (1)
-
- Control (1)
- Corn (1)
- Environmental temperature (1)
- Fan (1)
- Global positioning system (1)
- Grazing (1)
- Livestock behavior (1)
- Management practices (1)
- Obstruction (1)
- Packing factors (1)
- Phytase (1)
- Solid−state cultivation (1)
- Storage capacity (1)
- Stored product (1)
- Substrate moisture content (1)
- Temperature (1)
- Wheat (1)
Articles 1 - 5 of 5
Full-Text Articles in Entire DC Network
Seasonal Aeration Rates For The Eastern United States Based On Long-Term Weather Patterns, Michael D. Montross, Samuel G. Mcneill, Thomas C. Bridges
Seasonal Aeration Rates For The Eastern United States Based On Long-Term Weather Patterns, Michael D. Montross, Samuel G. Mcneill, Thomas C. Bridges
Biosystems and Agricultural Engineering Faculty Publications
Most aeration fans are sized to produce a minimum airflow rate of 0.1 m3/min/t (0.1 cfm/bu) in on-farm grain storage structures. At this airflow rate a significant amount of time is required to move a cooling front completely through a bin. The desired grain temperature and prevailing weather conditions will have a significant effect on required fan size. Thirty years of weather data were analyzed for the eastern United States to determine the amount of time available in temperature windows between 0 to 15.C and 0 to 17.C. Contour maps were generated with ArcMap 8.3 for the percentage …
Vertical Wall Loads In A Model Grain Bin With Non-Axial Internal Inserts, Marek Molenda, Michael D. Montross, Jozef Horabik, Sidney A. Thompson
Vertical Wall Loads In A Model Grain Bin With Non-Axial Internal Inserts, Marek Molenda, Michael D. Montross, Jozef Horabik, Sidney A. Thompson
Biosystems and Agricultural Engineering Faculty Publications
A study was conducted to estimate the degree of load asymmetry in a bin with non-axial internal inserts. Internal inserts in the form of an annulus segment were attached to the wall, and their influence on vertical wall loads during centric filling and discharge in a model bin were measured. Wall and floor loads were measured in a corrugated-wall model grain bin with a diameter of 2.44 m and a height of 7.3 m filled with soft red winter wheat to a depth of 6.7 m (height-to-diameter ratio of 2.75). Tests were conducted with inserts that extended circumferentially 30°, 60°, …
Effect Of Moisture Content And Broken Kernels On The Bulk Density And Packing Of Corn, Samuel G. Mcneill, Sidney A. Thompson, Michael D. Montross
Effect Of Moisture Content And Broken Kernels On The Bulk Density And Packing Of Corn, Samuel G. Mcneill, Sidney A. Thompson, Michael D. Montross
Biosystems and Agricultural Engineering Faculty Publications
Shelled yellow dent corn samples were conditioned to three moisture content levels (12%, 15%, and 18% w.b.) and mixed with a prescribed amount of broken corn particles of known size (geometric mean diameter of 1.0, 1.4, 2.0, 2.8, and 4.0 mm) and concentration (2.5%, 5.0%, and 7.5% by weight) levels. The initial bulk density and grain compaction under simulated overburden pressure tests were determined for each sample. Uniaxial compression tests were performed for seven vertical pressure levels (3.4, 6.9, 14, 28, 55, 110, and 165 kPa) with a minimum of three replications each. Tests were performed at two locations with …
Suitability Of A Gps Collar For Grazing Studies, Carmen T. Agouridis, Timothy S. Stombaugh, Stephen R. Workman, Benjamin K. Koostra, Dwayne R. Edwards, Eric S. Vanzant
Suitability Of A Gps Collar For Grazing Studies, Carmen T. Agouridis, Timothy S. Stombaugh, Stephen R. Workman, Benjamin K. Koostra, Dwayne R. Edwards, Eric S. Vanzant
Biosystems and Agricultural Engineering Faculty Publications
The traditional means of tracking animal location in a field is by visual observation. Not only is this method labor intensive, it is also prone to error as the observer can alter cattle movement, observation periods are often too short to obtain confidence in general daily behavior patterns, and observer fatigue becomes an issue. In the 1990s, the University of Kentucky began using GPS collars on cattle to track their position with the goal of incorporating this information into cattle management practices. One of the key unanswered questions regarding the GPS collars is the accuracy of the position data recorded …
The Influence Of Environmental Temperature And Substrate Initial Moisture Content On Aspergillus Niger Growth And Phytase Production In Solid−State Cultivation, Seaborn B. Carter, Sue E. Nokes, Czarena L. Crofcheck
The Influence Of Environmental Temperature And Substrate Initial Moisture Content On Aspergillus Niger Growth And Phytase Production In Solid−State Cultivation, Seaborn B. Carter, Sue E. Nokes, Czarena L. Crofcheck
Biosystems and Agricultural Engineering Faculty Publications
Aspergillus niger is being used commercially for phytase production utilizing solid-state cultivation; however, no studies have been published that investigated the optimal environmental temperature and initial substrate water content to maximize fungal growth and/or phytase production. Solid-state cultivations of Aspergillus niger on wheat bran and soybean meal were conducted at three temperatures (25°C, 30°C, and 35°C) and three initial moisture contents (50%, 55%, and 60% wet basis) in a split-plot full-factorial experimental design. Fermentations were conducted for 0, 24, 48, 72, and 120 h. The containers were sampled destructively and assayed for phytase activity and glucosamine concentration as an estimate …