Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 6 of 6
Full-Text Articles in Entire DC Network
Proton Diffusion In Nickel Hydroxide: Prediction Of Active Material Utilization, Sathya Motupally, Christopher C. Streinz, John W. Weidner
Proton Diffusion In Nickel Hydroxide: Prediction Of Active Material Utilization, Sathya Motupally, Christopher C. Streinz, John W. Weidner
Faculty Publications
Galvanostatic charge and discharge experiments reveal that the active material in nickel electrodes cannot be fully accessed at high currents or for thick films. It has been proposed that the utilization of the active material is controlled by the diffusion rate of protons through the film. This hypothesis is supported by the good agreement between mathematical simulations of material utilization and experimental data over a range of charge and discharge currents and film thicknesses. Furthermore, the fraction of material utilized is larger on charge than on discharge. The asymmetry on charge and discharge is due to a diffusion coefficient that …
Sr‐ And Ni‐Doped Lacoo3 And Lafeo3 Perovskites: New Cathode Materials For Solid‐Oxide Fuel Cells, Kevin Huang, Hee Y. Lee, John B. Goodenough
Sr‐ And Ni‐Doped Lacoo3 And Lafeo3 Perovskites: New Cathode Materials For Solid‐Oxide Fuel Cells, Kevin Huang, Hee Y. Lee, John B. Goodenough
Faculty Publications
An improved cathode material for a solid‐oxide fuel cell would be a mixed electronic and oxide‐ion conductor with a good catalytic activity for oxygen reduction at an operating temperature T op ≥ 700°C and a thermal expansion matched to that of the electrolyte and interconnect. We report on the properties of Sr‐ and Ni‐doped LaCoO3 and LaFeO3 perovskites that meet these criteria. Single‐phase regions were determined by X‐ray diffraction, and thermogravimetric analysis measurements were used to obtain the temperatures above which oxygen loss, and hence oxide‐ion conductivity, occurs. The conductivity and Seebeck measurements indicate the coexistence of both …
The Role Of Oxygen At The Second Discharge Plateau Of Nickel Hydroxide, Sathya Motupally, Mukul Jain, Venkat Srinivasan, John W. Weidner
The Role Of Oxygen At The Second Discharge Plateau Of Nickel Hydroxide, Sathya Motupally, Mukul Jain, Venkat Srinivasan, John W. Weidner
Faculty Publications
It was shown that the appearance of a secondary discharge plateau approximately 400 mV below the primary plateau can result from the reduction of oxygen. During the galvanostatic discharge of planar nickel-hydroxide films at room temperature and in 3 weight percent KOH solutions, the second discharge plateau was observed only in the presence of dissolved oxygen in the electrolyte. When the solution was deoxygenated, no residual capacity could be extracted from the films even at low discharge rates or from overcharged films. In addition, the duration of the second plateau is inversely proportional to the square of the discharge current, …
Electrochemical Investigations Of Cobalt-Doped Limn2O4 As Cathode Material For Lithium-Ion Batteries, P. Arora, Branko Popov, Ralph E. White
Electrochemical Investigations Of Cobalt-Doped Limn2O4 As Cathode Material For Lithium-Ion Batteries, P. Arora, Branko Popov, Ralph E. White
Faculty Publications
A wide range (y = 0.05–0.33) of Co-doped LiCoyMn2–yO4 spinels were synthesized and electrochemically characterized. These Co-doped spinels showed improved specific capacity and capacity retention over pure spinels. Electrochemical impedance spectroscopy and the linear polarization resistance technique were used to determine the transport and electrochemical kinetic parameters of Co-doped spinels. The presence of Co in the spinel inhibits the passivation process occurring on the surface of the cathode. Also, Co increases the exchange current density and facilitates the charge-transfer reaction of the active material. The lower self-discharge observed for Co-doped spinels was attributed …
Theoretical Analysis Of Metal Hydride Electrodes: Studies On Equilibrium Potential And Exchange Current Density, Bala S. Haran, Branko N. Popov, Ralph E. White
Theoretical Analysis Of Metal Hydride Electrodes: Studies On Equilibrium Potential And Exchange Current Density, Bala S. Haran, Branko N. Popov, Ralph E. White
Faculty Publications
A theoretical model for the metal hydride electrode has been developed assuming that hydrogen diffusion in the alloy and charge-transfer at the surface control the discharge process. Theoretical equations for the dependence of equilibrium potential and exchange current density on the surface hydrogen concentration have been derived. These parameters have been used to correlate experimental data with the theoretical electrode discharge model. Analysis of both the experimental and theoretical discharge curves reveals a potential plateau determined by the magnitude of the interactions between the hydrogen in the alloy and the unhydrided metal. Neglecting these hydrogen-metal site interactions results in simulations …
The Effect Of Particle Size On The Discharge Performance Of A Nickel-Metal Hydride Cell, Jussi M. Heikonen, Harry J. Ploehn, Ralph E. White
The Effect Of Particle Size On The Discharge Performance Of A Nickel-Metal Hydride Cell, Jussi M. Heikonen, Harry J. Ploehn, Ralph E. White
Faculty Publications
We investigate the effect of particle size on the discharge performance of a nickel-metal hydride cell with a mathematical model. Electrodes with uniform as well as with nonuniform particle sizes are studied. With uniform particle size, the dependence of the particle-to-particle resistance on the particle size is taken into account. The optimal particle size depends on the discharge rate. Moreover, we show that under certain conditions it is advantageous to use a nonuniform particle size. In general, the higher the discharge current density, the more the particle size affects the electrode performance.