Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Entire DC Network
Combinatorial Investigation Of Magnetostriction In Fe-Fa And Fe-Ga-Al, Jason R. Hattrick-Simpers, Dwight Hunter, Corneliu M. Craciunescu, Kyu Sung Jang, Makoto Murakami, James Cullen, Manfred Wuttig, Ichiro Takeuchi, Samuel E. Lofland, Leonid Bendersky, Noble Woo, Robert Bruce Vandover, Toshiya Takahashi, Yasubumi Furuya
Combinatorial Investigation Of Magnetostriction In Fe-Fa And Fe-Ga-Al, Jason R. Hattrick-Simpers, Dwight Hunter, Corneliu M. Craciunescu, Kyu Sung Jang, Makoto Murakami, James Cullen, Manfred Wuttig, Ichiro Takeuchi, Samuel E. Lofland, Leonid Bendersky, Noble Woo, Robert Bruce Vandover, Toshiya Takahashi, Yasubumi Furuya
Jason R. Hattrick-Simpers
A high-throughput high-sensitivity optical technique for measuringmagnetostriction of thin-film composition-spread samples has been developed. It determines the magnetostriction by measuring the induced deflection of micromachined cantilever unimorph samples. Magnetostrictionmeasurements have been performed on as-deposited Fe–Ga and Fe–Ga–Al thin-film composition spreads. The thin-film Fe–Ga spreads display a similar compositional variation of magnetostriction as bulk. A previously undiscovered peak in magnetostriction at low Ga content was also observed and attributed to a maximum in the magnetocrystalline anisotropy. Magnetostrictive mapping of the Fe–Ga–Al ternary system reveals the possibility of substituting up to 8at.%Al in Fe70Ga30 without significant degradation of magnetostriction.
Development Of A Metal-Printing 3d Printer At The University Of North Dakota, Benjamin Kading, Michaela Kegley, Tiana Delzer, Jeremy Straub, Scott Kerlin
Development Of A Metal-Printing 3d Printer At The University Of North Dakota, Benjamin Kading, Michaela Kegley, Tiana Delzer, Jeremy Straub, Scott Kerlin
Jeremy Straub
Three-dimensional (3D) printing is being used for numerous applications: from consumer hobbies to the development of aircraft parts. However, inexpensive 3D printers have been constrained in material selection to plastic. These printer use the fused deposition modeling (FDM) method of printing, which is a relatively new technology that utilizes computer numerical control (CNC) techniques to deposit melted material at specific places. Other methods, for example, include laser sintering and stereolithography. With 3D printing, layers are stacked upon each other and via this compilation of layers, a 3D object is formed. Currently there are a variety of materials that can be …
Fuzzy Logic Based Model For Predicting Surface Roughness Of Machined Al-Si-Cu-Fe Die Casting Alloy Using Different Additives-Turning
Faculty of Engineering University of Malaya
This paper presents a fuzzy logic artificial intelligence technique for predicting the machining performance of Al-Si-Cu-Fe die casting alloy treated with different additives including strontium, bismuth and antimony to improve surface roughness. The Pareto-ANOVA optimization method was used to obtain the optimum parameter conditions for the machining process. Experiments were carried out using oblique dry CNC turning. The machining parameters of cutting speed, feed rate and depth of cut were optimized according to surface roughness values. The results indicated that a cutting speed of 250 m/min, a feed rate of 0.05 mm/rev, and a depth of cut of 0.15 mm …