Digital Commons Network^™

Developing Computer Codes For Analyzing Bridge Response Due To Wim Data Truck Loading, Kenneth Patrick Pasley

Graduate Theses and Dissertations

Despite actual truck demographics evolving over the past 30 years, the Arkansas legal loads for bridge posting have not been updated. Custom computer codes were developed.to facilitate comparison between the current Arkansas legal loads for bridge posting and the actual Arkansas truck traffic to ensure that actual reactions are enveloped by the state'. The program, WIMFluence, calculates shear and moment influence lines for a bridge and the resulting shear and moment reactions based on weigh-in-motion data. With supporting scripts, the reactions due to actual Arkansas truck traffic were compared to those due to the current Arkansas legal loads for bridge …

Coastal Bridges Under Hurricane Stresses Along The Texas And Louisiana Coast, Adolfo Matamoros, Firat Testik

Publications

The main objective of this study is to develop a high-resolution model capable of simulating the response of bridge structures to hydrodynamic loads for hurricane design conditions (i.e., surge height, wave height, and frequency) expected in the Texas-Louisiana coast. The model relied on Coupled Eulerian-Lagrangian (CEL) techniques where solids are simulated with Lagrangian meshes, while fluids are simulated using Eulerian meshes, and was calibrated using historical data from wave impact laboratory tests. Two high resolution models were created, the first of a tsunami wave impact test conducted at Oregon State University and the second of a bridge located in the …

The Live Load Response Of The Open Web Steel Joist Black Slough Bridge, Piero Caputo

All Graduate Plan B and other Reports, Spring 1920 to Spring 2023

The bridge being studied spans the Black Slough River in the Nucor/Vulcraft facilities near Brigham City, Utah. The bridge is composed of seven heavyweight open web steel joists supporting a concrete deck-slab element and sitting in two concrete cantilever walls serving as bearings. A full-scale live-load test was performed using forklift vehicles at four locations on the deck. During the test, axial strains, deflections, and rotations where measured.

In their provisions, the American Association of State Highway and Transportation Officials (AASHTO) included a simplified number of equations and solutions used to calculate GDFs for standardized decks supported by beam systems. …

Detection Of Multiple Flaws In Concrete Bridge Decks Using Ultrasonic Wave Propagation, Ece Erdogmus, Eric Garcia, Michael Schuller, Donald Harvey, Kelsey Stithem, Monica Houck

Nebraska Department of Transportation: Research Reports

No abstract provided.

New Connection Details To Connect Precast Cap Beams To Precast Columns Using Ultra High Performance Concrete (Uhpc) For Seismic And Non-Seismic Regions, Mohamadreza Shafieifar

FIU Electronic Theses and Dissertations

Several connection details have been developed for the connection of precast cap beams to precast columns in Accelerated Bridge Construction (ABC) applications. Currently, the suggested details involve some form of either reinforcement or portion of the precast column to penetrate inside the cap beam. Such details present many challenges in the field, such as necessitating bundling of reinforcement in the cap beam or creating a congested reinforcement arrangement. Furthermore, closer inspection of some of the test data indicates that for currently used details, cap beams could sustain some damages during major seismic events, whereas they are designed to be capacity …

Development Of Iowa Dot Combination Bridge Separation Barrier With Bicycle Railing, Chaz M. Ginger

Department of Engineering Mechanics: Dissertations, Theses, and Student Research

The Iowa Department of Transportation typically builds separation barriers between vehicle and pedestrian/bicycle facilities when sidewalks or trails are present on vehicular bridges. Currently, Iowa DOT employs a combination bridge rail that utilizes a concrete parapet that previously had been successfully evaluated to National Cooperative Highway Research Program (NCHRP) Report 350 Test Level 4 (TL-4) criteria for these situations. While the parapet had been successfully evaluated, the combination bridge rail system as a whole had not been evaluated to any crash test standards. Iowa DOT desired that researchers at Midwest Roadside Safety Facility (MwRSF) design and test a combination bridge …

Effects Of Short-Term Strains On Concrete Bulb-Tee Bridge Girders And Analysis Of The Practicality Of Using Three-Dimensional Models Based On Drone Imagery To Aid In Bridge Inspections, Justin M. Pace

All Graduate Plan B and other Reports, Spring 1920 to Spring 2023

The University Transportation Center at Utah State University sponsors research through the Federal Highway Administration’s University Transportation Center Program. The purpose of this research is to advance technology and expertise in transportation-related fields. This includes research pertaining to bridge design, monitoring, and inspection (the focus of this research).

The first focus area of this research monitored short-term strains at the bottom of girders in a concrete bulb-tee girder bridge. The strains were caused by traffic loading and recorded using strain transducers attached to the bottom of each bridge girder. Patterns in the strain loading were monitored to draw conclusions about …

Structural Identification And Assessment Of The Inverted Tee Girder Bridge System, Garrett P. Martindale

Department of Civil and Environmental Engineering: Dissertations, Theses, and Student Research

The Inverted Tee (IT) girder bridge system was originally developed in 1996 by the University of Nebraska–Lincoln (UNL) and Nebraska Department of Roads (NDOR) engineers. This bridge system currently accounts for over 110 bridges in Nebraska used for both state highways and local county roads. Excessive transverse and longitudinal deck cracking has been observed and noted in numerous bridge inspection reports. Since the IT girder bridge system is relatively new, limited data and knowledge exist on its structural performance and behavior. This study evaluates the IT girder bridge system by conducting twenty field observations as well as recording accelerometer time …

Bio-Inspired Hybrid Vibration Control Methodology For Intelligent Isolated Bridge Structures, Mariantonieta Gutierrez Soto

Civil Engineering Faculty Publications

Inspired by evolutionary game theory, the biological game of replicator dynamics is investigated for vibration control of bridge structures subjected to earthquake excitations. Replicator dynamics can be interpreted economically as a model of imitation of successful individuals. This paper uses replicator dynamics to reduce vibrations while optimally allocating the control device forces. The control algorithm proposed is integrated with a patented neural dynamic optimization algorithm to find optimal growth rate values with the goal of achieving satisfactory structural performance with minimum energy consumption. A model is described for hybrid vibration control of smart highway bridge structures subjected to earthquake loading.