Open Access. Powered by Scholars. Published by Universities.®

Digital Commons Network

Open Access. Powered by Scholars. Published by Universities.®

Civil and Environmental Engineering

PDF

Western University

Analytical modeling

Articles 1 - 2 of 2

Full-Text Articles in Entire DC Network

Modal Analysis And Analytical Modeling Of Tornado-Like Vortices, Mohammad Karami Oct 2019

Modal Analysis And Analytical Modeling Of Tornado-Like Vortices, Mohammad Karami

Electronic Thesis and Dissertation Repository

Regardless of the type of vortex chamber, many tornado simulators generate flows that reveal similar flow patterns and a general agreement on the variations of the flow structures with swirl ratio (the ratio of tangential velocity to radial velocity) was achieved. However, very little is known about the underlying physics of the flow, mostly of the fluctuating one, as the previous studies have mainly focused on qualitative flow visualization and the quantitative description of the mean flow.

Herein, coherent structures in tornado-like vortices are extracted using modal decomposition techniques. Modal analysis helps us to better understand the complex vortex dynamics …


Analytical Modeling Of The Interface Between Lightly Roughened Hollowcore Slabs And Cast-In-Place Concrete Topping, Aiham Adawi, Maged A. Youssef, Mohamed E. Meshaly Jan 2015

Analytical Modeling Of The Interface Between Lightly Roughened Hollowcore Slabs And Cast-In-Place Concrete Topping, Aiham Adawi, Maged A. Youssef, Mohamed E. Meshaly

Civil and Environmental Engineering Publications

Hollowcore slabs are commonly used in different types of structures. They are usually topped with a 50 mm concrete topping. Structural engineers can use this topping to increase the slab load carrying capacity. North American design standards relate the horizontal shear strength at the interface between hollowcore slabs and the concrete topping to the slab surface roughness. This paper presents results of four push-off tests on hollowcore slabs supplied by two manufacturers and roughened using a conventional steel broom. The tested slabs sustained higher horizontal shear stresses than those specified by the design standards. Utilizing the data from the push-off …