Digital Commons Network^™

Characterization Of Two Biochars Derived From Horse Muck And Their Ability To Reduce Pathogen Transport In Soil, David Griffith

Theses and Dissertations--Biosystems and Agricultural Engineering

Biochars have been created and characterized from a variety livestock manure biomass including poultry, dairy, and swine. However, no research has been conducted on the physical and chemical makeup of biochar pyrolyzed from horse muck. Two horse muck derived biochars containing either straw (HS) or woodchip (HW) bedding were pyrolyzed at 700°C and characterized for their physical and chemical properties. Tests revealed both biochars had high alkalinity, moderate specific conductivity, and low surface area as compared to other biochars in the literature. HS contained more mineral structures than HW. Scanning electron microscopy presented differences in particle shape, size, and presence …

Commercialization Of A Small, Lightweight, Low-Cost Seismic Borehole Receiver, Rachel Adams

Theses and Dissertations--Civil Engineering

Herein, conceptualization of a recently patented seismic borehole receiver and its components is developed for commercialization. The device is significantly cheaper, lighter, and smaller than existing technologies on the market. Additionally, it has the potential to achieve better seismic readings than its competitors via patented sensor-to-borehole coupling mechanism. It is the hope that the commercialization of this device will not only provide a more affordable alternative to engineers and geophysicists in the existing market, but the significant cost difference may open new seismic measurement opportunities in the developing world. Its compact size and light weight will increase mobility, allowing investigators …

Life-Cycle Cost Analysis Of Reinforced Concrete Bridges Rehabilitated With Cfrp, Jeffrey L. Smith

Theses and Dissertations--Civil Engineering

The deterioration of highway bridges and structures and the cost of repairing, rehabilitating, or replacing deteriorated structures is a major issue for bridge owners. An aging infrastructure as well as the need to upgrade structural capacity for heavier trucks adds to problem. Life-cycle cost analysis (LCCA) is a useful tool for determining when the deployment of fiber-reinforced polymer (FRP) composite components is an economically viable alternative for rehabilitating deteriorated concrete bridges.

The use of LCCA in bridge design and rehabilitation has been limited. The use of LCCA for bridges on a project level basis has often been limited to the …

Sustainable Disposal Of Coal Processing Waste Streams, Mohammad Rezaee

Theses and Dissertations--Mining Engineering

Modern coal preparation facilities incorporate a wide array of solid-solid and solid-liquid separation processes for rejecting mineral matter to meet market specifications. The coarse mineral matter is typically placed into engineered refuse piles whereas the fine refuse is either stored in impoundments or co-disposed with the coarse refuse. The discharge water from the refuse material represents an environmental concern due to the potential release of trace elements, and the subsequent elevation of total dissolved solids and conductivity. The research findings reported in this dissertation addresses sustainable coal processing waste disposal through using strategies aimed at minimizing the environmental impacts. To …

Mechanical Behavior Of Grouted Sands, Ryan C. Ortiz

Theses and Dissertations--Civil Engineering

Grouting techniques have been in used for many years, but several new grout materials have surfaced in recent decades that have re-defined the boundaries of the limitations of grouting programs. Typically these applications are used for seepage control in earthen impoundments, but strength of these earthen impoundments should be considered where there is potential for movement in the grouted soil mass. This study investigated initial conditions that could affect grout application effectiveness. The initial conditions in question were soil grain size and in situ moisture content. Two grouts were used, ultrafine and acrylate, and variations in pure grout properties were …

Prediction Of Strength And Shear Modulus Of Compacted Clays Within An Unsaturated Critical State Framework, Corrie Walton-Macaulay

Theses and Dissertations--Civil Engineering

The objective of this research study is to determine whether the soil stiffness, from which the small-strain shear modulus is determined, can be used to predict the shearing resistance of compacted clay soil, which are invariably under conditions of partial saturation. The research program developed for this objective included three major soil testing programs of matric suction, shear modulus, and strength.

A method to estimate matric suction of field compacted clay soil was presented and it is based on the quantified effect of change in initial void ratio on the soil water characteristic behaviors. With the use of a non-nuclear …

Determination Of Explosive Energy Partition Values In Rock Blasting Through Small-Scale Testing, Joshua Calnan

Theses and Dissertations--Mining Engineering

Blasting is a critical part of most mining operations. The primary function of blasting is to fragment and move rock. For decades, attempts have been made at increasing the efficiency of blasting to reduce costs and increase production. Most of these attempts involve trial and error techniques that focus on changing a single output. These techniques are costly and time consuming and it has been shown that as one output is optimized other outputs move away from their optimum level. To truly optimize a blasting program, the transfer of explosive energy into individual components must be quantified. Explosive energy is …

Influence Of Calcium Sulfoaluminate Cement On The Pullout Performance Of Reinforcing Fibers: An Evaluation Of The Micro-Mechanical Behavior, Robert B. Jewell

Theses and Dissertations--Civil Engineering

The objective of this research was to determine the influence of calcium sulfoaluminate (CSA) cement on reinforcing fibers by evaluating the fiber pullout behavior, and bonding characteristics, of a single fiber embedded in a cementitious paste matrix. Four types of fibers commonly used in industry were evaluated: 1) Polyvinyl alcohol; 2) Polypropylene; 3) Coated Steel; and 4) Plain Steel.

Upward trends in energy costs and potential greenhouse gas regulations favor an increased use of construction materials that require lower energy and lower CO₂ emissions to fabricate, such as CSA cement, as opposed to the production of ordinary portland cement …

Shape Memory Behavior Of Single Crystal And Polycrystalline Ni-Rich Nitihf High Temperature Shape Memory Alloys, Sayed M. Saghaian

Theses and Dissertations--Mechanical Engineering

NiTiHf shape memory alloys have been receiving considerable attention for high temperature and high strength applications since they could have transformation temperatures above 100 °C, shape memory effect under high stress (above 500 MPa) and superelasticity at high temperatures. Moreover, their shape memory properties can be tailored by microstructural engineering. However, NiTiHf alloys have some drawbacks such as low ductility and high work hardening in stress induced martensite transformation region. In order to overcome these limitations, studies have been focused on microstructural engineering by aging, alloying and processing.

Shape memory properties and microstructure of four Ni-rich NiTiHf alloys (Ni50.3Ti29.7Hf20, Ni50.7Ti29.3Hf20, …

Development Of Techniques For Assessing And Restoring Streams On Surface Mined Lands, Whitney Cole Blackburn-Lynch

Theses and Dissertations--Biosystems and Agricultural Engineering

Surface mining is a commonly used method for extracting coal in the Appalachian Coalfields of the U.S. This mining practice produces excess spoil or overburden, which is often placed in adjacent valleys resulting in the creation of valley fills. These valley fills bury headwater streams, which in turn can negatively impact downstream ecosystems. In 2008, the University of Kentucky designed and constructed 1,020 m of ephemeral, intermittent and headwater streams on an existing valley fill (Guy Cove) as a proof-of-concept. The goal of the project was to evaluate whether or not a stream recreation could occur on mined lands, particularly …

The Applicability Of Western Management In The Middle East, Zamaan Al-Shabbani

Theses and Dissertations--Civil Engineering

The Middle Eastern construction industry is still suffering from cost overruns, delays, and disputes. Inefficient management practices and lack of management are frequently reported reasons for such problems. Researchers attribute such problems to the traditional management practices that are utilized in the Middle East. However, International companies who practice their best management strategies are still suffering from the same problems. These issues become more significant in joint ventures when two different management styles work together. Therefore, it becomes crucial to understand the characteristics of Middle Eastern construction environment in terms of the management practices and regulations that are used and …

Sediment Organic Carbon Fate And Transport In A Fluviokarst Watershed In The Bluegrass Region, Admin Husic

Theses and Dissertations--Civil Engineering

Mature karst topography is well recognized within the hydrology and geology communities to include subterranean fluid pathways that act as turbulent conduits conveying fluid from surface stream sinks called swallets to sources called springs. However, we find that little knowledge has been reported with regards to the transport and fate of terrestrially-derived sediment organic carbon (SOC) within karst watersheds. This study investigated the hypothesis that karst pathways could act as biologically active conveyors of SOC that temporarily store sediment, turnover carbon at higher rates than otherwise considered, and recharge depleted SOC back to the surface stream within the fluvial system. …

Deformation-Based Excavation Support System Design Method, Sekyi K. Intsiful

Theses and Dissertations--Civil Engineering

Development in urban areas around the world has steadily increased in recent years. This rapid development has not been matched by the ever decreasing open space commonly associated with urban centers. Vertical construction, thus, lends itself a very useful solution to this problem. Deep excavation is often required for urban construction. Unfortunately, the ground movements associated with deep excavation can result in damage to adjacent buildings. Thus, it is critically important to accurately predict the damage potential of nearby deep excavations and designing adequate support systems.

A new design method is proposed, as an attempt, to address the problem. The …

Vibration Of Steel-Framed Floors Supporting Sensitive Equipment In Hospitals, Research Facilities, And Manufacturing Facilities, Di Liu

Theses and Dissertations--Civil Engineering

Floors have traditionally been designed only for strength and deflection serviceability. As technological advances have been made in medical, scientific and micro-electronics manufacturing, many types of equipment have become sensitive to vibration of the supporting floor. Thus, vibration serviceability has become a routinely evaluated limit state for floors supporting sensitive equipment. Equipment vibration tolerance limits are sometimes expressed as waveform peak acceleration, and are more often expressed as narrowband spectral acceleration, or one-third octave spectral velocity.

Current floor vibration prediction methods, such as those found in the American Institute of Steel Construction Design Guide 11, Floor Vibrations Due to Human …

Determining Soil Erosion With Varying Corn Stover Cover Factors, Nicole K. Koeninger

Theses and Dissertations--Biosystems and Agricultural Engineering

Since the Dust Bowl, conservation agriculture has become a common practice globally. Because of the rising interest in the use of corn biomass as a feedstock for biofuel production, the effects of corn stover removal on soil erosion were explored. It was hypothesized that selective harvesting strategies would impact soil erosion differently across a variety of slopes. Soil erosion boxes were constructed, and a rainfall simulator with an intensity of 30 mm hr^-1 for 46 min was used to create runoff from slopes of 1, 5, and 10% and three cover factor treatments (no removal and two simulated corn …