Open Access. Powered by Scholars. Published by Universities.®

Digital Commons Network

Open Access. Powered by Scholars. Published by Universities.®

Chemical Engineering

PDF

Louisiana State University

LSU Doctoral Dissertations

Theses/Dissertations

2013

Drilling

Articles 1 - 2 of 2

Full-Text Articles in Entire DC Network

Analytical Modeling And Diagnosis Of Penetration Rate Performance Of Pdc Bits, Reza Rahmani Jan 2013

Analytical Modeling And Diagnosis Of Penetration Rate Performance Of Pdc Bits, Reza Rahmani

LSU Doctoral Dissertations

The high cost of drilling deep (15000+ ft) wells, due to slow rate of penetration (ROP) at depth, has severely limited the utilization and economic significance of deep hydrocarbon resources. The overall objective of this study was to obtain a better understanding of the major cause(s) of slow ROP in deep drilling. An analysis of field data demonstrated the impact of the problem and identified shale and limestone as the primary lithologies where slow ROP occurs at depth. Previous researchers have concluded that interactions between rock, drilling fluid, cuttings, and the bit control ROP. More specifically, several researchers have concluded …


An Experimental And Computational Investigation Of Rotating Flexible Shaft System Dynamics In Rotary Drilling Assemblies For Down Hole Drilling Vibration Mitigation, Richard Duff Jan 2013

An Experimental And Computational Investigation Of Rotating Flexible Shaft System Dynamics In Rotary Drilling Assemblies For Down Hole Drilling Vibration Mitigation, Richard Duff

LSU Doctoral Dissertations

Rotary drilling system vibration has long been associated with damaging the bit, the bottom hole assembly (BHA) and drill string. Vibration has been traditionally measured in the bottom hole assembly, and been closely associated with the resonant behaviors.

This research study proposes an improved physical laboratory model to explore the dynamic behaviors associated with vibration. This model includes contact with the borehole wall allowing a range of stabilization geometries while removing bit-formation interaction effects. The results of exercising the model help develop new insights into both vibration measurement diagnostics and mitigation strategy execution.

Presented here is a review of other …