Open Access. Powered by Scholars. Published by Universities.®

Digital Commons Network

Open Access. Powered by Scholars. Published by Universities.®

Aerospace Engineering

Open Access Theses

Theses/Dissertations

2013

Applied sciences

Articles 1 - 2 of 2

Full-Text Articles in Entire DC Network

Analysis Of Cyberattacks On Unmanned Aerial Systems, Andrew Morris Shull Jan 2013

Analysis Of Cyberattacks On Unmanned Aerial Systems, Andrew Morris Shull

Open Access Theses

With the increasing power and convenience offered by the use of embedded systems in control applications, such systems will undoubtedly continue to be developed and deployed. Recently, however, a focus on data-centric systems and developing network-enabled control systems has emerged, allowing for greater performance, safety, and resource allocation in systems such as smart power grids and unmanned military aircraft. However, this increase in connectivity also introduces vulnerabilities into these systems, potentially providing access to malicious parties seeking to disrupt the operation of those systems or to cause damage. Given the high potential cost of a failure in these systems in …


Flow And Heat Transfer In An L-Shaped Cooling Passage With Ribs And Pin Fins For The Trailing Edge Of A Gas-Turbine Vane And Blade, Irsha Ashok Pardeshi Jan 2013

Flow And Heat Transfer In An L-Shaped Cooling Passage With Ribs And Pin Fins For The Trailing Edge Of A Gas-Turbine Vane And Blade, Irsha Ashok Pardeshi

Open Access Theses

Efficient and effective cooling of the trailing edges of gas-turbine vanes and blades is challenging because there is very little space to work with. In this study, CFD simulations based on steady RANS closed by the shear-stress transport turbulence model were performed to study the flow and heat transfer in an L-shaped duct for the trailing edge under two operating conditions. One operating condition, referred to as the laboratory condition, where experimental measurements were made, has a Reynolds number at the duct inlet of ReD = 15,000, coolant inlet temperature of Tinlet = 300 K, wall temperature of …