Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Entire DC Network
Cfd Investigation Of Effect Of Depth To Diameter Ratio On Dimple Flow // Computational Fluid Dynamics Investigation Of Effect Of Depth To Diameter Ratio On Dimple Flow Dynamics, Robert B. Etter
Theses and Dissertations
This study aimed to further the understanding of laminar flow through a dimple with the goal of mitigating flow separation. Dimples of various depth to diameter ratios (0.05, 0.15) were examined for three different dimple diameters and chordwise locations, corresponding to diameter based (ReD) and chordwise location based (Rex) Reynolds number combinations of ReD 20500\Rex 5000, ReD 20500 Rex 77000, and ReD 9000 Rex 21000. For the last combination, a dimple of depth to diameter ratio of 0.25 was also examined. The dimples were placed in a flat plate located in a diverging channel causing an adverse pressure gradient encouraging …
Riblet Effects On Gortler Vortex Development Over A Concave Surface, James A. Rothenflue
Riblet Effects On Gortler Vortex Development Over A Concave Surface, James A. Rothenflue
Theses and Dissertations
Riblet effects on Goertler vortex development in laminar and transitional flows were measured using three-dimensional laser-Doppler anemometry. Three freestream velocities were tested such that riblet spacing corresponded to Goertler vortex (GV) wavelengths which presumably would be either strongly amplified, weakly amplified, or attenuated by centrifugal forces on a curved surface. Experiments revealed the development of paired, counterrotating vortices within the riblet valleys over both flat and concave surfaces. For riblet spacings equivalent to weakly or non-amplified GV wavelengths, GV development on a curved surface was above the riblets and was delayed by the addition of riblets. The GV wavelength was …
Performance Characterization Of A Highly-Offset Diffuser With And Without Blowing Vortex Generator Jets, Michael B. Senseney
Performance Characterization Of A Highly-Offset Diffuser With And Without Blowing Vortex Generator Jets, Michael B. Senseney
Theses and Dissertations
The effect of blowing vortex generator jets (VGJs) on the performance of a highly-offset (s-duct) diffuser was investigated experimentally. VGJs are pitched, skewed jets which generate streamwise vortices as well as injecting high-momentum fluid into the boundary layer. Diffuser performance with and without VGJs was measured for an inlet Mach number of 0.6 (Re/x = 1.27x107 per cm). Pitot static and hot-film instrumentation was used to measure flow properties at the diffuser inlet and exit planes. Without blowing, the flow on the lower surface of the diffuser was massively separated. Blowing at 0.48% mass flow ratio through three lower-surface …